Terrano terrano-x Operation & User’s Manual

CONTENTS OF BOX IMPORTANT: If you purchased the double pack, your retail box will include two sets of each component listed except for the Quick Start Guide. TERRANO-X Channel B Button • Connects to Channel B / D Volume Down / Rewind Button USB cabl ...

Use the USB cable to charge the unit for at least 3 hours before initial use. Channel “B” / Channel “D” Channel “A” / Channel “C” While charging, the RED LED turns on. When charging is complete, the LED will turn off. GENERAL FUNCTIONS Power ON/ OFF Press for 2 seconds • ON: 3 BLUE flashes, Ascending tone ...

1 BLUE flash every 3 seconds Standby mode No active audio sources 2 BLUE flashes every 3 seconds Active mode–Call in progress / music or other audio source is ON 1 RED flash every 3 seconds Low-battery Beep every 3 minutes Standby mode–Battery is low 2 RED flashes every 3 seconds Low-b ...

Helmet Type 1: Of-center vents Helmet Type 2: Center vents (go to page 5) (go to page 6) Short Buckle Strap Long Strap Velcro Side Smooth Side Velcro Side Smooth Side Front Front Back Back ➊ ➋ Cradle Spoiler Optional Spoiler Deflect branches or other objects Press here Connect the Spoiler Remove the Spoiler Cradle Spoile ...

Helmet Type 1 Cradle (Bottom) Short Buckle Strap Smooth Side Continue on page 7 Continued on page 8 ...

Back Front Cradle (Top) Long Strap Smooth Side ...

Wait TEN minutes Preview: Final Audio Kit Position Attaching the Left Speaker (Optional) NOTE: Using two speakers inside the helmet may be prohibited in certain jurisdictions. If you wish to use two speakers, you should connect the left speaker to the audio kit as shown below. Cradle Audio Kit Conne ...

Back If needed, use the adhesive pads to hold the speaker wires in a comfortable location Inner helmet view Front Back Inner helmet view Front Audio Kit Cradle Audio Kit Connector Audio Kit R L R L R ...

Attach the Headset Release the Headset CLICK! CLICK! ...