Symbol P360 Quick Reference Manual

Text of the manual

P360/460 Memory Scanners

© 2001 - 2006 SYMBOL TECHNOLOGIES, INC. All rights reserved. Symbol reserves the right to make changes to any product to improve reliability, function, or design. Symbol does not assume any product liability arising out of, or in connection with, the application or use of any product, circuit, or application described herein. No l

Quick Reference Guide

3 Introduction The Phaser 360/460 Memory Scanners bring new flexibility and economy to data capture and data management in both retail and industrial operations. In addition to an integrated bar code scanner, the Phaser has an on-board keyboard and display. They can operate in both corded and battery-powered cordless modes. There are se

P360/460 Memory Scanners

Disconnecting Cables Most hosts require RS-232 cables. All other hosts require Synapse cables. To disconnect the Phaser scanner cable: 1. Power down all devices connected to the Phaser scanner cable. 2. Remove the cable by turning the cable twist-lock 1/8 turn counter-clockwise and pulling the cable out. Installing or Changing the

Quick Reference Guide

5 2. Slide the battery towards the bottom of the scanner and pull the bottom of the battery up and out of the scanner. Replacing the Battery 1. Seat the battery fully in the scanner and then slide it up the handle. 2. Replace the battery compartment cover and slide the release latch up to secure the cover in place. Powering Up the Scann

P360/460 Memory Scanners

• Corded scanning scans and transmits data, via cable, to the host. • Batch (uncorded) scanning scans and stores data. To transmit batched data to the host, press the 1 key combination, then insert the scanner in its cradle, or attach its cable. The scanner automatically switches between these applications by monitoring for

Quick Reference Guide

7 Host Communication With some terminal types, the Phaser scanner is unable to answer host terminal polls until the appropriate host type is selected. This may result in an error message generated by the host computer. Contact the System Administrator for assistance. Aiming Hold at an Angle Do not hold the scanner directly over the bar

P360/460 Memory Scanners

Beeper Indications When one beep sounds (short high tone) it means data was decoded successfully. If any other beeps sound, contact the technical person in charge of scanning. Troubleshooting If the scanner does not work after following the operating instructions in this guide: • check the system power. • check that scanning is

Other Barcode Reader Manuals