3M MP 180 Operator's Manual

© 2010 3M. All Rights Reserved. 3 English Contents Intended Use Statement.......................................................................... 4 Safety Information................................................................................... 4 Safety Labels ......................................................................................... 7 Introduction............................................................ ...

4 © 2010 3M. All Rights Reserved. English Intended Use Statement The 3M™ 180 Projector is designed to operate with the 3M-specified battery and 3M power adapter in normal office or home environments. • 10˚–35˚C (50˚–95˚F) • 10–80% RH (without condensation) • 0–1829 m (0–6000 feet) above sea level The ambient operating environment should be free of airborne smoke, grease, oil and other contaminants that can ...

© 2010 3M. All Rights Reserved. 5 English m Warning To reduce the risk associated with hazardous voltage: • Do not modify this product in any way. Use only 3M-approved replacement components. • Do not attempt to service this projector other than battery replacement. There are no user-serviceable parts other than the battery. Service to be performed only by a 3M-authorized service provider using 3M-approved system components. ...

6 © 2010 3M. All Rights Reserved. English m Warning To reduce the risk associated with fire and explosion, battery leakage or overheating: • Do not immerse the battery in water or allow it to get wet. • Do not reverse the positive(+) and negative(-) terminals. • Do not connect the battery directly to a wall outlet. Use only the 3M-specified wall charger or automobile charger. • Do not strike, throw or subject the batter ...

© 2010 3M. All Rights Reserved. 7 English y leakage M-specified ot ecomes dor. y leaks and ct to volume level. tion: government tripping hazard. LITHIUM ION BATTERY Model No. LIN370-001 28.86Wh (11.1V 2600mAh x 3) P/N 78-6972-0026-5 m Warning • Use a specified charger. • Do not throw the battery into fire or heat. • Do not short-circuit the battery terminals. • Do not disassemble the battery. Charging Specification Stand ...

8 © 2010 3M. All Rights Reserved. English Package Contents 1 3M 180 Projector 2 Table-Top Tripod 3 Rechargeable Battery 4 Carrying Pouch 5 Outlet Adapters (4) 6 Power Adapter 7 AV Adapters (3) 8 Product Warranty and Safety Guide 9 Quick Start Guide 10 AV Cable 11 VGA-Audio Cable 12 MicroSD Memory Card 13 USB Cable 1 2 4 6 8 9 11 3 5 7 10 12 13 ...

© 2010 3M. All Rights Reserved. 9 English Parts 1 Status Indicator 2 Touch Screen 3 Focus Wheel 4 Lens 5 Speaker 6 Flip Stand 7 Tripod Socket 8 Battery 9 Battery Latch 10 Power Button 11 Remote Sensor 12 Earphone Jack 13 Mini USB Port 14 VGA-A/V Input 15 DC Power Input 3 4 5 5 6 7 13 14 8 15 10 12 11 9 1 2 ...

10 © 2010 3M. All Rights Reserved. English Remote Control (optional extra) 1 back 2 up 3 zoom 4 left 5 OK 6 right 7 play 8 down 9 pause 2 3 1 5 6 4 8 9 7 ...

© 2010 3M. All Rights Reserved. 11 English Getting Started Install Battery The 3M projector comes with a rechargeable battery. The battery should be fully charged before using the projector with the battery. To install the battery: point the contacts on the battery toward the contacts on the projector, insert the end farthest from the battery latch first, then push down until the battery clicks into place. Remove Battery To remo ...

12 © 2010 3M. All Rights Reserved. English Power Adapter The power adapter is used to charge the battery or power the projector. There are four outlet adapters to give you the flexibility to power the 3M 180 in most countries. You can also power the projector with the 3M 180 car charger, available separately. Installing an Outlet Adapter onto the Power Adapter 1 Select the outlet adapter that will plug into your wall outlet. 2 ...

© 2010 3M. All Rights Reserved. 13 English Charge the Battery The 3M 180 rechargeable battery gives you up to two hours of battery life. When the battery needs to be charged, the status indicator will flash red or the low battery message will display. The battery should be fully charged before using the 3M 180 projector. Charge the battery by connecting the 3M 180 power adapter to the projector. When the power adapter is conne ...

14 © 2010 3M. All Rights Reserved. English Battery Charging Notes: • If the projector power is off, allow three hours for the battery to fully recharge. If the projector power is on, the battery will take longer to charge. • The battery has a lifespan and ages every time it is fully charged and discharged. The battery will gradually loose charge capacity as it ages. Therefore, as the battery ages the battery life will decre ...

© 2010 3M. All Rights Reserved. 15 English Making Connections The 3M 180 projector will display informational icons depending on the input device and signal being detected. If no devices or input cables are connected to the projector, the home screen will display. The 3M 180 was designed to operate with the 3M VGA and AV cables only. Connecting to a Composite Video Device Use the AV cable to input video from camcorders, digita ...

16 © 2010 3M. All Rights Reserved. English Connecting to a Component Video Device For component video input, you must purchase the optional 3M 180 Component AV Cable. This cable sends a higher quality video signal for the best possible image. 1 Connect the component AV cable to the projector’s VGA-AV input. 2 Connect the other end of the AV cable to the video device’s audio and video outputs. Important Note: There are two r ...

© 2010 3M. All Rights Reserved. 17 English Connecting to a Computer Use the VGA-audio cable to connect the projector to desktop computers, laptop computers, ultra-portable computers and some personal digital assistants (PDAs). The projector supports VGA, SVGA, XGA, and WXGA resolutions. For best results, set the computer’s resolution to SVGA (800x600). 1 Connect the VGA cable to the 3M 180 projector. 2 Connect the VGA cable to ...

18 © 2010 3M. All Rights Reserved. English Basic Operating Instructions Powering On Press and hold the power button for three seconds. Release the power button when the projector begins to project an image and the status indicator turns green. Tip: The video output on some devices is turned off by default. Please refer to the device’s documentation for details on enabling the video output. Powering Off Press and hold the powe ...

© 2010 3M. All Rights Reserved. 19 English Status Indicator Light The status indicator light provides information about the projector’s state. Status Indicator Light Meaning Flashes green three times A new power source is connected to the projector and the projector is ready to be powered on. Blank Projector is off. If the power adapter is connected to the projector, and the battery is installed, the battery has finished charg ...

20 © 2010 3M. All Rights Reserved. English Adjusting Image Size The 3M 180 projector can project a diagonal image of 10 to 60 inches (254–1524 mm). Refer to the chart for associated dimensions. Diagonal Size Image Width Image Height Projector-to- Screen Distance 14 in (35.56 cm) 11 1/4 in (28.4 cm) 8 3/8 in (21.3 cm) 11 3/4 in (29.9 cm) 20 in (50.8 cm) 16 in (40.6 cm) 12 in (30.5 cm) 16 3/4 in (42.7 cm) 26 in (66.04 cm) 20 3/ ...