Olson Technology OTLT 3000 Instruction Manual

Text of the manual

OTLT / OTLR 3000 Manual

L-Band Fiber Optic Link 500 - 3,000 MHz INSTRUCTION MANUAL REV. X4 06/19/08 (209) 586-1022 (800) 545-1022 (209) 586-1026 E-Mail: [email protected] www.olsontech.com

L-Band Fiber Optic Link

1 SAFETY 3 Safety Precautions 3 Laser Safety Procedure 3 GENERAL FEATURES 4 RF PERFORMANCE 4 OPTICAL PERFORMANCE 6 DC POWERING AND ALARMS 6 Flying Lead Signal Description: 7 INSTALLATION 7 Optical Connectors 7 Cleaning Optical Connectors 8 Physical Size 8 Mounting 9 TYPICAL Applications 10 MDU (Mul

The optical emissions from the units are laser-based and may present eye hazards if improperly used. NEVER USE

ANY KIND OF OPTICAL INSTRUMENT TO VIEW THE OPTICAL OUTPUT OF THE UNIT. Be careful when working with optical fibers. Fibers can cause painful injury if they penetrate the skin. Laser Safety Procedure ALWAYS r

The OTLT linear fiber optic transmitter and the OTLR linear fiber optic receiver form the basic L-Band Fiber Distribu-

tion System. The wide bandwidth of 500MHz to 3,000MHz allows for a wide variety of communications applications including L-Band satellite antenna remoting, trunking radio, telemetry tracking and time and frequ

Single Mode 9/125μm ( Corning SMF-28 or Equivalent)

Tx/Rx Optical Return Loss >55dB Tx/Rx Optical Connector SC/APC (Standard) FC/APC (Optional) Rx Wavelength 1270-1610nm Rx Optical Input Power -15 to +3dBm Rx Alarm Standalone Optical Input Power Low ( Open Collector Output) Trip level set for optical levels l

The Rx standalone unit can be powered though the RF connector, this feature can be enabled or disabled (Factory

Preset) by moving internal jumper, see picture below. The Rx unit is normally fed via the two flying leads, the Red Wire is +8VDC to +24 VDC and the Black Wire is ground or -. The flying cable also has a shield wire that can be conne

Cleaning Optical Connectors

Fiber optic connectors on the cable come pre-terminated should be clean and capped, so one can usually remove the cap and make the connection without cleaning the connector, but, if there is any doubt it is good practice to clean the optical connectors before making the connection. Once the connection is made, there

Other Transceiver Manuals