OM POWER OM3500A Instruction Manual

Text of OM POWER OM3500A Instruction Manual

SHORTWAVE POWER AMPLIFIER

OM POWER, s. r. o. 930 30 Báč 126 SLOVAKIA

Important safety instructions:

• The amplifier contains high voltage circuits. Never turn the amplifier on without the upper lid in place. • The OM3500A amplifier is neither to be used in a wet or humid environment nor to be exposed to rainfall. • The amplifier must be installed in such a way that free flow of hot air from the tube is allowed. The amplifier must not be installed in a constrained surrounding (i.e. tight shelves etc.) • During long o

General description of the OM3500A Amplifier

The linear amplifier OM 3500A is designed for all short wave amateur bands from 1.8 till 29 MHz (including WARC – bands ) and all modes . It is equipped with a ceramic tetrode GU78b. The OM3500A is automatically tuned to operating frequency of your TRX. Specification of OM3500A Frequency coverage: amateur bands 1.8 – 29.7 MHz including WARC Power output: 3500 W in SSB

General Description of OM3500 A POWER AMPLIFIER

HF PART In this amplifier a tetrode GU 78b is used in a grounded-cathode circuit (input into control grid). This amplifier achieves excellent linearity by the voltage stabilization of the control grid bias and the screen voltage. The power input is given to the control grid, using a broadband input circuit with an input impedance of 50 Ohms. This adaptable input circuitry ensures a good input SWR better than

Power supply of the amplifier is effected by two 2,5 kVA toroidal transformers. A soft start is

realized with the help of relays and resistors. The high anode voltage consists of 8 times 420V and 2A. Each of them has its own rectifier and filter. In the high voltage circuit safety resistors are employed to protect the amplifier against overload. The source for screen grid is stabilized by a parallel stabilization with BU508 transistors and de

The amplifier is connected to the mains with 2 cables with a EURO end. Each cable is to be

switched to another phase of your main supply system! Both of them have to be able to deliver a power of 2.5 kVA ! If you use only one phase, you have to connect both cables to this one phase ! Your main supply has to be able to deliver 5 kVA on this one phase! In this case the power amplifier can’t deliver full output! ATTENTION: In each case the pow

Control of the amplifier is possible remotely by using REMOTE BOX (optional). Connection

is done by REMOTE socket, maximum cable length of 10 meters. I / O box . Control of Amplifier and communication with TRX as well as antennas / BPF switching can be done via I / O Interface KEY IN - Input signal PTT (switching voltage / current 5V / 2mA) KEY OUT - Output signal PTT (maximum switching of 30V / 50mA) Control cable Control cable maintains TX /

- Mono 3.5mm Jack for connection of ICOM TRXs. For successful

operation selection of ICOM radio and correct baud rate is important (9600 default) TCVR - DB-9 -serial port RS232 for YAESU, KENWOOD, ORION and ELECRAFT TRXs. Correct baud rate and TRX type is a must for successful operation. If both CI-V and TCVR cables are used then CI-V wins over RS232. Otherwise selection of interface is done via TRX type. PC - DB9 RS232 port is used for communication

OM POWER Amplifier Owners Instructions: