RS IT-1 Instruction Manual

Text of RS IT-1 Instruction Manual

IT-1 Infrared Thermometer English

2 SECTION 1 – SAFETY INFORMATION Safety Information Understand and follow operating instructions carefully. Use the tester only as specified in these instructions otherwise, the protection provided by the tester may be impaired. -- To ensure safe operation and service of the tester, follow these instructions. -- Failure

IT-1 Infrared Thermometer English

3 Symbols as marked on the tester and instruction manual CE certification This tester is certified to the following standards : EN 61326-1 Electromagnetic Emissions and Susceptibility EN 61010-1 General Safety EN 60825-1 Laser Safety Battery See instruction card Do not apply directly to or around bare HAZARDOUS LIVE condu

IT-1 Infrared Thermometer English

4 Tester Description Operating Instructions Power On / Off Press the key until the display activates Auto Power Off : 3 minutes. AAA Battery Torch Laser LCD Torch Key Test Key Battery Cover Battery Indicator ℃/ ℉ Laser Indicator NCV Indicator press

IT-1 Infrared Thermometer English

5 Temperature Measurement When powered on, press the key, the tester will show the temperature of the measured target. Then release the key, the LCD will hold the reading for 10 seconds. The laser light points out the measuring direction during the temperature test. Take care, do not stare into the beam Continuous Measure

IT-1 Infrared Thermometer English

6 °C / °F Selection Press the key and the key for 2 seconds at the same time to switch the temperature tester between oC and oF Notes on making Temperature Measurements For accurate temperature measurements, allow the tester to acclimatize to the ambient temperature for 30 minutes. 25℃/ 77 ℉ 3 95 5℃/ ℉ wait for 3

RS Thermometer Owners Instructions: