Rostra 250-8406 Manual 

REARSIGHT ITEM QTY DESCRIPTION 1 1 INTERFACE ADAPTER HARNESS 2 1 REAR CAMERA ASSEMBLY 3 1 CAMERA EXTENSION HARNESS 4 1 SACK PARTS NOTE: KIT CONTENTS HARDWARE BAG CONTENTS ADDITIONAL ITEMS REQUIRED FOR INSTALL FORM #5485 REV. A 04-02-14 CONFLICTS RECOMMENDED TOOLS VEHICLE TRIM COLOR COLOR APPLI ...

A 1 250-8530 CAMERA EXTENSION HARNESS B 1 250-8147 CCD REAR CAMERA ASSEMBLY 2 1 250-8598 SACK PARTS: TIE STRAPS, FOAM TAPE, SEALING PUTTY *BEFORE BEGINNING INSTALLATION, FAMILIARIZE YOURSELF WITH THE INSTALLATION INSTRUCTIONS AND THE REARSIGHT TM BACK-UP ...

TAPE TO DISENGAGE THE 4 CLIPS AND REMOVE THE AIR CONDI- TIONER CONTROL ASSEMBLY. DISCONNECT ALL CONNECTORS. FIGURE 1 2. REMOVE 4 (10MM BOLTS) AND DISENGAGE THE 5 CLIPS AND REMOVE THE RADIO RECEIVER ASSEMBLY WITH BRACKET. DISCONNECT ALL CONNECTORS. FIGURE 2 3. DISENGAGE THE 2 CLIPS T ...

5. USE A T30 TORX SOCKET WRENCH TO REMOVE 7 SCREWS AND DISENGAGE CLIPS TO REMOVE THE TAIL GATE PROTECTOR. FIGURE 5 6. USE A T30 TORX SOCKET TO RELEASE 8 SCREWS AND REMOVE THE TAILGATE SERVICE HOLE COVER. FIGURE 6 7. DISCONNECT THE CONNECTOR AND REMOVE EXISTING WIRING CABLE IN TAILGATE. REMOVE (2)10MM ...

1. CONNECT THE INTERFACE ADAPTER HARNESS INTO RADIO RECEIVER CONNECTOR HOUSING R32 AS SHOWN IN FIGURE 9. 2. LOCATE WHITE CONNECTOR R31 FROM THE RADIO RECEIV- ER THAT CONNECTS BESIDE THE INTERFACE ADAPTER HARNESS CONNECTION. BE SURE TO PULL OUT TERMINAL RETAINER AT THE CENTER OF CONNECTOR. FIGURE 10. INSERT TERMI- NAL FRO ...

CAMERA 1. ROUTE THE CAMERA EXTENSION HARNESS TO SCUFF PLATE AREA AND THROUGH THE ACCESS GROMMET UNDERNEATH CAR- PET. USE THE EXISTING WIRING WITH WIRE CLIPS TO SECURE HARNESS. FIGURE 14. CONTINUE ROUTING THE HARNESS ALONG THE FRAME WIRING BELOW VEHICLE AND TO TAILGATE AREA. 2. ROUTE THE CAMERA EXTENSION HARNESS THROUGH ...

3 FT LBS. RE-ENTER ANY THEFT DETERRENT INFORMATION IF APPLICABLE. 2. TURN THE IGNITION SWITCH ON. PUT THE VEHICLE IN REVERSE. VERIFY THAT THE RADIO DISPLAY IS ON AND THAT THE CAMERA’S PICTURE APPEARS. 3. IF THERE IS NO PICTURE, VERIFY ALL CONNECTIONS ARE SECURE. REASSEMBLY 1. REINSTALL ALL TRIM PIEC ...