Monogram ZICS36N RH Installation Instructions Manual

GE Monogram® Installation Instructions Stainless Steel Bottom Mount Built-In Refrigerators Models ZICS36N RH ZICS36N LH ...

IMPORTANT - Save these instructions for local inspector’s use. IMPORTANT - OBSERVE ALL GOVERNING CODES AND ORDINANCES. Note to Installer - Be sure to leave these instructions with the Consumer. Note to Consumer - Keep these instructions with your Use and Care Book for future reference. ...

Flush or Semi-Flush Enclosure Installations True Flush Installation In a flush installation, the refrigerator doors will align evenly with the front face of adjacent cabinet doors. The refrigerator blends into the surrounding cabinetry. Semi-Flush Installation These refrigerators can also b ...

Installation At End-of-Run Frameless Cabinets NOTE: 1/2" thick side panels shown. Side panels can be any thickness. Add side panel thickness to outside trim width (36") to calculate the rough-in dimension. The leading (front) edge must be finished to match su ...

ZICS36N RH Handle on the left side, the door swings left to right. ZICS36N LH Handle on the right side, the door swings right to left. A – 36" outside trim width B – 35" case width C – 10-3/4" D – 72-1/4" E – 84" Shipping height Adjustable from 83-1/2" to 84-1/2" F – 24-3/4 ...

Grounding the Refrigerator IMPORTANT - (Please read carefully) FOR PERSONAL SAFETY, THIS APPLI- ANCE MUST BE PROPERLY GROUNDED. The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (ground- ing) wall receptacle to minimize t ...

Tools Required •Tinsnips to cut banding •Stepladder •Bucket •Level •Appliance Hand Truck •Tubing cutter •7/16" open-end wrench •#2 Phillips screwdriver •Stubby Phillips screwdriver Materials Required •Side panels to match cabinetry •2x4, 36" long, for Anti-Tip support, ...

•A cold water supply is required for automatic icemaker operation. The water pressure must be between 20 and 120 p.s.i. •Route 1/4" OD copper tubing between house cold water line and the water connec- tion location. •Copper tubing should be long enough to extend to the front of the refrigerator. A ...

•Side panels are required whenever the sides of the refrigerator will be exposed and when installed between frameless cabinets. See pages 3 and 4. •Side panels are not required when the refrigerator is installed into an enclosure. •Side panel installation will be determined by the design of the si ...

5 Level Refrigerator Step 6 Optional Anti-Tip Precaution Step This refrigerator has 4-point leveling. The front is supported by leveling legs, the rear is supported by wheels. •Adjust rear wheels beneath the refrigerator to just barely touch the 2x4 block. •Turn the 7/16" hex nut located abo ...