Mopar Dodge Installation Instructions Manual

1 2 Backup camera harness to Telematics Gateway Module (TGM) connector 1 3 Backup camera connector 1 4 Zip ties 12 5 High mount brake lamp with trunk release button and backup camera 1 6 Splice Kit (includes 2 splice collars and shrink tube) 1 NOTE: All views are Dodge unles ...

PROCEDURE STEPS: 1. Tilt the RH seat back for access to the B­pillar lower panel retaining screw (not shown, under the cover, 2), if equipped. 2. If equipped, using trim stick C­4755 or equivalent, re­ move the RH B­pillar lower trim panel screw cover and remove the retaining screw. Nov 16, 2010 K6861117 ...

4. Place the ignition switch to the On position, apply the service brakes and place the gear selector lever into the Neutral position. 5. Place the ignition switch to the Off position. 6. Using a small flat bladed tool or equivalent, separate the retaining ring (1) and slide down the shifter shaft. 7. Remove the spare tire cove ...

lease while pulling up on the shifter knob (3). 10. Remove the shifter knob (3) and retaining ring (2). 11. Using a trim stick C­4755 or equivalent, gently pry be­ tween the shifter bezel (1) and the floor console to re­ lease the snap retainers that secure the bezel.Do not pull with excessive f ...

Failure to follow these instructions will damage or break the wires and/or connector. CAUTION: Push the 40 way connector in before push­ ing on the locking clip. Failure to follow these instruc­ tions will damage or break the connector locking clip. 18. Push in on the 40 way connector (1) of the switch� ...

way Module (TGM) (2) and pull out far enough to ac­ cess the connectors on the back of the TGM. CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connec­ tor could damage the cable or radio. 22. Disconnect the antenna(s) (1), RF HUB and UCI ca­ bles ...

alent, gently pry between the instrument panel and the floor console side close out panel (1) to release the two snap retainers that secure the close out panel to the instrument panel. 27. Using a trim stick C­4755 or equivalent, gently pry be­ tween the floor console side close out panel (1) ...

luggage compartment. 33. Behind the RH rear seat, pull the carpet tab (5) up, exposing the rear seat back side bolster bracket re­ taining bolt (4). 34. Remove the RH rear seat back side bolster bracket bolt (4). 35. Remove the push­in fasteners (3) that secure the trunk side trim. 36. Using a trim ...

carefully pry the quarter trim (1) at three points (2) loose enough to remove the C­pillar trim (3). 39. Using a trim stick C­4755 or equivalent, carefully pry the C­pillar trim (1) inward to loosen the push­in re­ tainers, then pull forward and down to remove from the vehicle. 40. Fold back ...

routed through the deck lid trim. 43. Remove the two bumper stops (3) and the nine push­in retainers (1) from the deck lid and remove the deck lid trim from the deck lid. 44. Remove the wheel well cover trim as follows: a. On the RH side, remove the cargo net hook screw (1) and upper cargo hook (2). b. On ...