Motion 35XT Operation & User’s Manual

Text of Motion 35XT Operation & User’s Manual

The lightning bolt flash with arrowhead

symbol, within an equilateral triangle, is intended to alert the user to the pres- ence of potentially “dangerous voltage” within the product’s enclosure that may be sufficient to consti- tute a risk of electric shock. In accordance with the European Union WEEE (Waste Electrical and Electronic Equipment) direct

WARNING! Turn your amplifier

off before making or breaking any signal connections! Use the best speaker cables you can. The length and type of speaker cable used in your system will have an audible effect. Under no circumstance should a wire of gauge higher (thinner) than #16 be used. In general, the longer the length used, the greater the neces

SINGLE WIRE CONNECTION

Please take note of the jumper clips installed under the binding posts. These clips attach the high-frequency and low-frequency sections of the crossover together. Leaving these in place, con- nect the (+) wire from your amplifier to either red (+)binding post and the (–) wire from your ampli- fier to either black (–) binding pos

amplification directly connected to the high- and

low-frequency sections of the crossover. There are two different methods for bi-amping with two stereo amplifiers. The first and most common is referred to as Horizontal Bi-amping. The second method is referred to as Vertical Bi-amping. With either meth- od you may use two stereo amplifiers or four mono amp

Motion Speakers Owners Instructions: