Remcor DB200 Operator's Manual

Text of the manual

PRINTED IN U.S.A

âREMCOR INC: 1993--97 Part No. 91679 May 1997 Revision E THIS DOCUMENT CONTAINS IMPORTANT INFORMATION This Manual must be read and understood before installing or operating this equipment

TABLE OF CONTENTS

Page SAFETY PRECAUTIONS 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GENERAL DESCRIPTION 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLATION INSTRUCTIONS 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Always disconnect power to the dispenser before servicing or cleaning.

Never place hands inside of hopper or gate area without disconnecting power to the dispenser. Agitator rotation occurs automatically when the dispenser is energized! This ice dispenser has been specifically designed to provide protection against personal injury

REMCOR “K”Model Ice/Beverage dispensers are designed to be used with one of several type top mount ice-

makers. This must be obtained from the appropriate manufacturer. Check with your REMCOR Sales Coordinator for a list of icemaker kits available. This kit will contain parts and instructions necessary to connect the icemaker to the ice

GATE RESTRICTOR PLATE

CAUTION: Disconnect power to dispenser before installing, removing or adjusting restrictor. FIGURE 1. GATE RESTRICTOR PLATE ADJUSTMENT This dispenser is provided with a gate restrictor plate (Figure1), installed in its highest position. This plate ad- justs the rate of ice flow from the dispenser. In applications using buckets,

SHADED AREA INDICATE OPENINGS

IN CABINET BOTTOM NEEDED FOR UTILITIES AND BEVERAGE TUBING 27 3/4-IN. 1 1/8-IN. 1 1/8-IN. 20 3/4-IN. 30-IN. 14-IN. 8 5/8-IN. 17-IN. 6 1/2-IN. 30-IN. 3/8 DIA. HOLE (4) PLCS FIGURE 2. MOUNTING TEMPLATE

SHADED AREA INDICATE OPENINGS

IN CABINET BOTTOM NEEDED FOR UTILITIES AND BEVERAGE TUBING 27- 3/4-IN. 1- 1/8-IN. 20 -3/4-IN. 30-IN. 14-IN. 30-IN. 8-IN. FRONT 7-IN. 23-IN. 7- 15/16IN. 4-1/2 IN. 1 -1/8-IN. BACK REMOVABLE SINK 3/8 DIA. HOLE (4) PLCS FIGURE 3. MOUNTING TEMPLATE

1) TO SERVICE COLDPLATE INLET FITTINGS, SINK HAS TO BE REMOVED.

TO REMOVE, DISCONNECT SINK DRAIN CONNECTIONS, THEN LIFT TWO (2) SIDE MOUNTING PINS AND PULL SINK FORWARD. REVERSE TO RECONNECT. 2) MAKE SURE ALL DRAIN CONNECTIONS ARE PROPERLY POSITIONED FOR DRAINING AFTER SERVICE, BEFORE PANELS ARE INSTALLED. 3) DO NOT USE INLETS. FIGURE 6. PLUMBI

Other Beverage Dispenser Manuals