Rocom ECII Operation & User’s Manual

1. Content of delivery ...............................................................................................................................2 2. PIN-code................................................................................................................................................2 3. Installation ................. ...

1. Content of delivery - GSM Gateway - Antenna - GSM Gateway Manual (this document) - Power adapter 230VAC/12 VDC 2. PIN-code Note: The GSM gateway must always be switched off before inserting or removing the SIM-card. The SIM-card does not need to have a PIN-code activated. If the SIM-card has a PIN-code activated it must be set to “1234”. ...

4. Front panel connectors and indications USB PHONE PWR/STAT BATT PHONE 1 USB USB 2.0 Mini connector to be used for connection with a PC. The USB can be used for updating the software of the GSM Gateway and also for adjusting parameters, such as battery tripping limits. LED Indicators LED Status Indicates PWR/STAT 1000 ms ON / 1000 ms OFF 100 ms ...

GSM Indicates OFF Faulty GSM unit 800 ms ON / 800 ms OFF No service, No connection with GSM or SIM-card missing. 100 ms ON / 1500 s OFF Connection with the GSM network OK, Backup power in use ON Normal status. Connection with the GSM network OK , AC-powered S1 and S2 Indications for GSM signal strength (Green LED): S1 S2 Signal strength OFF OFF ...

6.2 Battery fault alarm A “battery fault alarm” is indicated the same way as “low battery voltage indication” (6.1) but can also be sent by SMS. Please view SMS functionality for information on settings or how to use the USB connector and 1258 Manager software. The first battery test is made after 48 hours and the following every 24 hour ...

The GSM will acknowledge a correct programming by returning a SMS as above. In the example below the battery alarm level is changed to 4.0 V (4000 mV). SMS to GSM Gateway SMS from GSM Gateway The GSM will acknowledge a correct programming by returning a SMS as above. In this example a battery alarm will generate the following SMS from the GSM Ga ...

SMS to GSM Gateway SMS from GSM Gateway The GSM Gateway will acknowledge a correct programming by returning a SMS as above. In this example when the battery is changed it will generate the following SMS from the GSM Gateway: SMS from GSM Gateway Both functions described above are switched off by sending the following SMS to the GSM Gateway: SMS ...

The SMS is acknowledged with a SMS from the GSM Gateway. The Battery replaced SMS (Bares) function described above can be switched off separately by sending the following SMS to the GSM Gateway: SMS to GSM Gateway SMS from GSM Gateway The SMS is acknowledged with an SMS from the GSM Gateway. 7.2 Dial tone 2 The dial tone 2 indicating a battery a ...

8. Upgrade Tool The USB interface is used to configure user specific parameters and to upgrade the GSM Gateway firmware. The upgrade requires the Windows program “1258 Manager” and is available from Rocom GmbH or your local distributor. Use a standard USB – miniUSB cable to connect the GSM Gateway to the PC. - Install the “1258 Manager� ...