Patton SmartNode 2290 Series Quick Start Manual

Leased-Line Extenders over IP Quick Start Guide Important—This is a Class A device and is intended for use in a light industrial environment. It is not intended nor approved for use in an industrial or residential environment. Part Number: 07M2292-QS, Rev. B Revised: February 9, 2012 Sales Office: +1 (301) 975-1000 Technical Support: ...

1.0 Installing the SmartNode extender 1.1 Mounting the SmartNode extender Place the extender on a desktop or similar sturdy, flat surface that offers easy access to the cables. The extender should be installed in a dry environment with sufficient space to allow air circulation for cooling. For proper ventilation, l ...

3 2. Installing the 10/100 Ethernet port cable or cables (see 1.4 “Installing the Ethernet cable” on page 5) 3. Installing the power input (see 1.5 “Connecting to external power source” on page 6) 1.3 Installing an interface cable on the extender’s voice ports The SmartNode extender comes with at least ...

Figure 3. FXO connection Figure 4. RJ-11 pinout diagram Note Unit must not connect directly to telecom network voltage (TNV). Table 1. RJ-11 socket Pin Signal 3 Ring (-) 4 Tip (+) RJ-11, male RJ-11, male PSTN wall plate , 1.25A Reset Ports ETH 0/1 ETH 0/0 Socket 6 5 4 3 2 1 Plug 1 2 3 4 5 6 Link 100M Activity 0/0 0/1 ...

5 1.4 Installing the Ethernet cable The SmartNode 2292 Series has automatic MDX (auto-cross-over) detection and configuration on the Ethernet ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable (see figure 5). Ethernet devices (10Base-T or 100Base-T) are connected t ...

Figure 6. Connecting to a host 1.5 Connecting to external power source The extender comes with an external power supply. This section describes installing the power cord into the extender. Do the following: Note Do not connect the power cord to the power outlet at this time. 1. Insert the barrel type connector en ...

7 Figure 7. Steps for setting up a new SmartNode 2.1 Configure the IP address Power connection and default configuration First the SmartNode must be connected to the mains power supply with the power cable. Wait until the 'Run' LED stops blinking and lights constantly. Now the SmartNode is ready. The factory default c ...

Connect with the serial interface The Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (see figure 8) between the SmartNode’s Console port and a PC or workstation’s RS-232 serial interface. Activate the terminal emulation program on the PC or workstation that supp ...

9 2.2 Login 1. Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to display. Type the factory default login: administrator and leave the password empty. Press the Enter key after the password prompt. login:administrator password: 172.16.40.1> 2. Afte ...

3.0 Additional Information For detailed information about configuring and operating guidance, set up procedures, and troubleshooting, refer to the SmartNode 2290 Series User Manual available online at www.patton.com/manuals/ SN2290.pdf and the SmartWare Software Configuration Guide available online at www.patton.c ...