PC Electronics TX70-.1s Operation & User’s Manual

Text of the manual

P. C. Electronics 2522 Paxson Lane Arcadia CA 91007-8537 USA ©2014

Tel: 1-626-447-4565 m-th 8am-5:30pm pst (UTC - 8) Tom (W6ORG) & Mary Ann (WB6YSS) Web site: http://www.hamtv.com Email: ATVinfo @ hamtv.com TX70-.1s 70 CM ATV TRANSMITTER USERS MANUAL The TX70-.1s transmitter is designed to provide 50 - 100 mW continuous duty peak

POWER INPUT JACK. A 2.1 x 5.5mm plug cable is provided

for connection to your source of +12 to14 Vdc. Currant draw is <500 MA in transmit. Center of the plug and the marked side of the cable is +, all black is - or ground. If used at a repeater site, make a cable using RG174 coax. The TX70- .1s works best from a well regulated voltage source

LINE AUDIO INPUT. High level line audio usually from the

same source as plugged into the companion Video input is plugged into this jack using another RCA phono plug shielded cable. Minimum level is .1 v pk-pk into a 10K load. The level is controlled by the line audio gain knob. LINE AUDIO GAIN control varies the high level audio applied to the subcarrier

DX vs. POWER vs. ANTENNA GAIN. The 100 mW output of the

TX70-.1s was chosen to provide an easy low cost entry into the world of ATV, but at the same time give flexibility to all the applica- tions that hams might put the equipment to. 100 mW connected to OAL 5L-70cm beams for short distance video up to 5 miles with low battery drain public service applicati

More PC Electronics Transmitter Owners Instructions: