Max-Thrust Ryan STA Assembly And Instruction Manual

Assembly and Instruction Manual Warning: This radio controlled model is not a toy. It requires skill to fly and is not recommended for the novice pilot. It should not be operated by children without the supervision of a suitably experienced adult. Max-Thrust reserves the right to modify the specification of this model at ...

2) Never fly this model over roads, railway lines, near to power lines, airports, buildings or any people. 3) Do not fly this model in excessively strong winds, in the rain, or thunderstorms. 4) Do not fly or launch the model towards people. 5) Keep hands and face ...

Spring Pack Undercarriage Tail Wheel Hardware Pack Live Hinges Tools required to complete 1. Screwdrivers 4. Scissors 2. Pliers 5. Measure or Ruler 3. Modelling Knife Additional items required to complete 1350mAh 3S 11.1V Li-Po battery (POWER-TECH 1350mAh 33C ...

aircraft. When using screwed fixings with “EPOFLEXY” components it is important to tighten the screws sufficiently to provide a firm fixing. Excess tightening could result in the foam material becoming compressed, possibly damaging or distorting the part ...

horizontal tail plane and push the fin assembly into position. Remove any excess adhesive immediately. Secure in place using an M2 x 40mm screw at the front mounting point and an M2 x 30mm screw at the rear mounting point via the fixing holes positioned underneath the fuselage, (image 7) 4. Fusela ...

from the topside of the wing to the cockpit using the screw pack supplied with the them (image 11). Once the main build has been completed, you may wish to fit the wire rigging. The rigging is purely cosmetic and won't alter the flight characteristics of the model, but does enhance the scale appearance. ...

that all leads are routed in a neat and tidy manner. Mount the receiver inside the fuselage, using your choice of double sided self-adhesive or “Velcro” tape. The receiver should be fixed inside the fuselage securely where it will not foul any moving parts (image ...