Midmark 425 Assembly Instruction

Text of Midmark 425 Assembly Instruction

Sheet 1 of

Introduction These assembly instructions are intended to assist you in assembling Midmark's Model #425 and #427 Stools. Please follow these instructions to assure proper assembly. Unpacking EQUIPMENT ALERT To avoid damage, do not use a knife or any other sharp object for opening cartons. Assembly Remove the stool from the carton. Depending on the optional items that you purchased, assemble the stool in the following order: - Optional Lab Height

Sheet 2 of

4 FIGURE 2 Optional Armrest Assembly Optional Backrest Assembly FIGURE 3 FIGURE 4 FIGURE 5 Insert the armrest bar into the arm channel and under the mounting plate (see Figure 2). Align the two tapped holes in the armrest bar with the two arm mounting slots in the mounting plate. Using the supplied 5/32 Allen Key, drive the two 1/4-20 x 3/8 screws through the mounting plate and into the armrest bar. Repeat the above procedure with the other a

Sheet 3 of

4 Adjustments Height Adjustment of Stool Lower the 425 stool by grasping the release handle, (see Figure 2) and pull up. This will open the valve in the gas cylinder. The weight of the operator will com- press the gas in the cylinder allowing the stool seat to lower. Once the desired height is reached, release the handle. The handle will snap back to its original posi- tion locking the cylinder's vertical position. To raise the stool, grasp

Sheet 4 of

© Midmark Corporation - 1995 4 003-0458-00 Rev. J (8/15) Midmark Corporation 60 Vista Drive P.O. Box 286 Versailles, OH 45380-0286 1-800-MIDMARK Fax 877-249-1793 www.midmark.com SCOPE OF WARRANTY Midmark Corporation (“Midmark”) warrants to the original retail purchaser that it will repair or replace components of the domestic and international medical products manufactured by Midmark (except for components not warranted under “Exclusions

Midmark Indoor Furnishing Owners Instructions: