Selecon 5.5-13 Operation Manual

Version 3.1: September 2007 © 2007 Selecon New Zealand Limited All Rights Reserved OPERATION MANUAL PACIFIC VERY NARROW ZOOMSPOT MODELS: 5.5-13 and 7-19 For Pacific MSR, CDM, 80V Power System please refer to the additional instruction sheets as well. For Pacifi ...

2 Version 4 October 2010 Important! Read this manual from cover to cover before attempting to install, operate or maintain the luminaire to which it relates. It contains important installation, operating, maintenance and safety procedures. The customer must strictly comply with them. Along with such procedures mentioned in this docum ...

3 Version 4 October 2010 Lamp module GKV 600/800W Lamp Module 80V 1200W Lamp Module BP1000W Lamp Module CDM 150 …………..Blue Handle Red Handle Black Handle Please read this information carefully to ensure that you are fully conversant with its operation. Subject ...

4 Version 4 October 2010 Safety Warnings 1.0m D = 90o Not for residential use. CAUTION: Hot Surfaces, Avoid contact by persons or materials. The Pacific has some hot surfaces. Be careful to avoid burns. Take care with the lamp house and Heat sink. We suggest the use of leather gloves when focusing these luminaires. SAFETY – Mains P ...

5 Version 4 October 2010 For ease of shipping, the Pacific VNZ is supplied with the lamp house removed. Attach the lamp house by sliding it into the guides on the rear of the lens tube, and then fastening the lamp house locking clamp. Attach the supplied safety chain between the luminaire anchor point, and the rear anchor point of th ...

6 Version 4 October 2010 Centre the lamp in the middle of the beam if necessary, by adjusting the three levelling screws. Optimising the output The lamp position can be altered to 'Peak' or 'Flat' light output. The peak beam gives a central hot spot falling off evenly to the beam edges. This setting is useful for normal stage lighti ...

7 Version 4 October 2010 Mounting your luminaire A safety bond MUST always be used when rigging luminaires on bars, ladders, etc. The safety bond is passed through the luminaire lamp-house anchor ring located at the rear of the luminaire and around the bar. This is the only recommended anchor point for the luminaire. Be careful to a ...

8 Version 4 October 2010 Operating your luminaire Please note that as the handles and knobs on the Pacific range can reach high temperatures depending on the position or orientation of the luminaire, and that gloves should always be worn when focusing these luminaires. Pan and Tilt Adjustment To pan the luminaire, loosen the nut at t ...

9 Version 4 October 2010 A unique feature of the Pacific range is the ability to use plastic transparencies for projection instead of conventional steel or glass gobos. This can only be done if the Pacific is configured correctly. For detailed information please refer to our website: www.seleconlight.com The Pacific provides for moun ...

10 Version 4 October 2010 Safe Practice Heat The Pacific incorporates an innovative design to effectively remove the heat out of the luminaire, away from the critical heat-sensitive components such as the lamp base and wiring. The components that form part of the heat removal system, the heat-sink and lamp house, will operate at temp ...