Phoenix Model GRIPEN Instruction Manual

GRIPEN EDF 90MM ARF SCALE 1:7 SPECIFICATION - Wingspan: 1084mm (42.7 in) - Length: 1655mm (65.1 in) - Flying weight: 5.9 - 6.1 kg - Wing area: 42dm2 - Wing loading: 140g/dm2 - Wing type: Naca airfoils - Retract gear type: Mechanic retract gear with CNC Suspension Metal Struts (included) - Radio: 6 - 9 channel . 6 mini h ...

• Medium C/A glue • 30 minute epoxy • 6 minute epoxy • Hand or electric drill • Assorted drill bits • Modeling knife • Straight edge ruler SUGGESTION To avoid scratching your new airplane, do not unwrap the pieces until they are needed for assembly. Cover your workbench with an old towe ...

2 3. Place the servo into the servo tray. Center the servo within the tray and drill 1,6mm pilot holes through the block of wood for each of the four mounting screws provided with the servo. 4 4. Using the thread as a guide and using masking tape, tape the servo lead to the end of the thread: carefully pull the ...

1. Working with the aileron linkage for now, thread one clevis at least 14 turns onto one of the threaded wires. 8. Insert the 90 degree bend down through the hole in the servo arm. Install one nylon snap keeper over the wire to secure it to the arm. Install the servo arm retaining screw and re ...

GEAR 1. Install the servo retract to the fuselage as photo below. 2. Install the adjustable servo connector to the servo arm of the servo retract gear. 3. Secure the main retract to the mounting of landing area. 4. Connect the metal rod of retract gear to the servo connector. 5. Secure the wheel. 18 Servo retract 19 S ...

1. Trim the plastic wheel well. 6. Lock-up the axle. GRIPEN 90MM Instruction Manual 23 Remove the plastic C.A glue 24 2. Glue the wheel well by C.A glue. 22 Screw 5 Servo arm Wheel Adjustable servo connector Metal rod Control horn Retract Servo arm Metal rod Wheel Adjustable servo connector Control horn Retract Gear Gear cl ...

3. Install the servo retract. GRIPEN 90MM Instruction Manual 6 25 Servo retract 31 Crimp 30 M3 Clevis 26 27 Connector 28 29 Screw Screw Screw 4. Install the adjustable servo connector to the servo arm of the servo retract gear. 5. Install the retract gear to the mounting of nose gear area. 6. Connect the metal rod of retract gear t ...

33 34 INSTALLING THE HORIZONTAL STABILIZER Gear close Gear OPEN Adjustable servo connector Adjustable servo connector Metal rod Metal rod Servo arm Servo arm Cable steering nose Retract Gear Cable steering nose Crimp Crimp Steering nose arm Steering nose arm Spring Spring ...

38 60mm 4. Make the same way from installing the aileron linkages for installing the elevator linkges. 1. Metal rod control set. 3. Attach and secure the horizontal stabilizer to the fuselage using aluminum control horn. Each co ...

stabilizer. Remove the covering 46 49 7. Repeat these step from installing the aileron linkages to install the rudder linkages. 4. Secure the servo plate. 5. Remove the covering. 48 C.A glue 47 Remove the covering 6. Install and glue the rudder control horn. 45 3. Install the rudder servo to the servo ...