Phoenix Model RAINBOW 2000 Instruction Manual

- Length: 1544mm (60.7 in) - Flying weight: 3600-3800 gr - Wing area: 66 dm2 - Wing loading: 55g/dm2 - Wing type: Naca airfoils - Covering type: Genuine ORACOVER® - Gear type: Aluminum main gear and spring tail gear (included) - Radio: 4 channel minimum (not included) - Servo: 5 standard servo: ...

• Medium C/A glue • 30 minute epoxy • 6 minute epoxy • Hand or electric drill • Assorted drill bits • Modeling knife • Straight edge ruler • 2 bender plier • Wire cutters • Masking tape • Thread lock • Paper towels • Rubbing alcohol SUGGESTION To avoid scratching your new airplane, do not un ...

1. One aileron control horn in positioned on each aileron. Using a ruler and a pen, locate and mark the location of the control horn. It should be mounted on the bottom side of the aileron at the leading edge, in line with the aileron pushrod. 2. Drill two 1.6mm holes through the aileron using the control horn as a guide an ...

aileron linkage. After both linkages are completed, connect both of the aileron servo leads using a Y-harness you have purchased separately. 11 To the cowl Silicone Tube 10 To the cowl 3. Repeat step # 1 - # 2 to install the control horn on the opposite aileron. 2. Attach the clevis to the outer hole in the c ...

19 3. Check the fit of the horizontal stabilizer in its slot. Make sure the horizontal stabilizer is square and centered to the fuselage by taking measurements, but don't glue anything yet. 4. With the horizontal stabilizer correctly aligned, mark the shape of the fuselage on the top and bottom of the tail plane using a water soluble / n ...

drew as a guide, carefully remove the covering from between them using a modeling knife. When cutting through the covering to remove it, cut with only enough pressure to only cut through the covering it's self. Cutting into the balsa structure may weaken it. This could lead to possible failure duri ...

correctly, mix up a generous amount of 30 minute epoxy. Apply a thin layer to the slot in the mounting platform and to the vertical stabilizer mounting area. Apply epoxy to the lower rudder hinge. Set the stabilizer in place and re-align. Double check all of your measurements once more before the epoxy cur ...

Locate the long piece of wire used for the throttle pushrod. One end of the wire has been pre-bend in to a "Z" bend at the factory. This "Z" bend should be inserted into the throttle arm of the engine when the engine is fitted onto the engine mount. Fit the engine to the engine mount using the screws ...

1. The stopper has been pre-assembled at the factory. 2. Using a modeling knife, cut one length of silicon fuel line (the length of silicon fuel line is calculated by how the weighted clunk should rest about 8mm away from the rear of the tank and move freely inside the tank). Connect one end of the line to the weigh ...

44 SERVO INSTALLATION INSTALLING THE FUSELAGE SERVOS 1. Install the rubber grommets and brass collets into the elevator, rudder and throttle servos. Test fit the servos into the servo tray. Trim the tray if necessary to fit your servos 2. Mount the servos to the tray using the mounting screws provided with y ...