Phoenix Model Thunderbolt P47 Instruction Manual

Length: 1410mm (55.51 inches) Weight: 3500gr - 4000gr Engine: 61 two stroke - 91 four stroke Radio: 6 channel / 8 servos standard g The Thunderbolt P47 was perhaps the greatest of world war II in terms of all - round performance and capability. Phoenix Model has recreated a 2C - 60 class engine (or 4c 91 class). It was designe ...

during assembly. We recommend that you regroup the parts in the same manner. This will ensure you have all of parts required before you begin assembly AIR FRAME ASSEMBLIES . (2) Wing halves with ailerons . (1) Fuselage with canopy . (1) Horizontal stabili ...

• Medium C/A glue • 30 minute epoxy • 6 minute epoxy • Hand or electric drill • Assorted drill bits • Modeling knife • Straight edge ruler • 2 bender plier • Wire cutters • Masking tape • Thread lock • Paper towels • Rubbing alcohol SUGGESTION To avoid scratching your new airplane, do not un ...

servo within the tray and drill 1,6mm pilot holes through the block of wood for each of the four mounting screws provided with the servo. Remove the covering 3 INSTALLING THE AILERON SERVOS 1. Install the rubber grommets and brass eyelets onto the aileron servo. 2. Using a modeling knife, remove the co ...

1. Working with the aileron linkage for now, thread one nylon clevis at least 14 turns onto one of the 2mm x 180mm threaded wires. 8. Insert the 90 degree bend down through the hole in the servo arm. Install one nylon snap keeper over the wire to secure it to the arm. Install the servo arm retaining screw and remove the mask ...

1. Landing air retract. 16 Collar 21 15 4. Install the tube to the air retract. 3. Prepare the air tube. 6. Glue the plastic part by C.A glue. 5. Remove the covering. 7. Pull out the air tube through the wing section. 2. Install and secure the retract gear into the wing. ...

screws. 23 Plastic collar 8. Secure the air retract to the wing. 9. Install the window using the plastic collar. 10. Make the same way for install the second landing gear. 25 26 27 Metal connector Zip tie 1. Install the servo to the fuselage. 2. The air ...

1. Using a modeling knife, cut away the covering from the fuselage for the stabilizer and remove it. 30 2. Remove the covering from the stabilizer. When cutting through the covering to remove it, cut with only enough pressure to only cut through the covering it's self. Cutting into the balsa structure may weaken it. T ...

Repeat step 1 - step 5 from the installing aileron for the installing rudder. 35 38 39 2. Set the tail wheel assembly in place on the plywood plate. 3. Drill 2,6mm pilot holes through the plywood plate. 4. Secure the tail wheel bracket in place using two 3mm x 12mm screw. 5. Align the tail wheel wire so that ...