Planet ICA-HM620 Quick Installation Manual

Verify the Contents Inside the Package Box........................................................ 3 Physical Installation.......................................................................................... 4 Further Configuration.......................................................................................12 ...

The package should contain the items below. If any item is missing or damaged, please contact the seller immediately. Dome Camera with Dome Cover Compact Pendent Mount Outdoor Mount Kit Waterproof Rubber Terminal Block Bracket Screw Kit Security Tool Lubricant M3/M5 Standard Screws M3/M5 Security Screws AC Power Adapter Quick Installation Guide CD-ROM Power Cord ...

to avoid damage to the device and injury to the installer. 2. Please make sure the hardware is fastened on the wall properly to avoid unnecessary accidents. Double-check the hardware again after the installation. 3. Please check whether or not the power supply voltage is suitable for the device. The wrong power supply voltage will damage the device. Step 1 Unpack the Dome Camera’s package and take out the Dome Camera unit. Step 2 Tighten the knob to remove the dome cover and the lens protector. ...

to the cover’s water-proof rubber to make the installation process smoother. Note The tiny protrusion on the dome cover must align with one of the four holes on the dome body. Step 4 Gently pressure the dome cover downward with two hands on the side of it. DO NOT press the cover, as shown in the figure; this might cause damage to the camera body. ...

Step 6 Make a cable entry hole on the wall to recess the cables. Otherwise, users could push up the Cable Entry Board on the Compact Pendent Mount’s Mounting Plate to place the cables, as shown in the photo on the right. Step 7 Fix the Compact Pendent Mount on the wall with proper screws and screw anchors. After this step, attach the Waterproof Rubber to the Outdoor Wall Mount. Note The screws and screw anchors are not in the package. ...

Note 1. The network cable is not in the package. 2. Please block the cable entry hole with the supplied sponge to avoid insects entering the Pendent Mount. The sponge can be placed in two ways as shown in the illustrations below. ...

to the Compact Pendent Mount with the supplied screws and washers. Then adjust the Waterproof Rubber to the joint. Step 10 Connect power wires of AC adapter with Power Input connector of data cable. Please check the color of power wire carefully, and screw that with connector properly. Blue Yellow/Green Brown Black Green White Caution Wrong wiring could cause permanently damage to the device. ...

Camera.   ...

and washers. Note Rotate the dome camera until the two screw holes match the dome camera with the outdoor mount kit. Step 13 The adapter with the power cord attached is connected to a power outlet where the power voltage matches. Voltage Switch Note Use only the power adapter shipped with the unit to ensure correct functionality ...

external power if connected to IEEE 802.3at High Power over Ethernet (PoE plus) switch. AC Ethernet Switch Speed Dome User PC (192.168.0.X) Note 1. For ICA-HM620, if there is a need to operate the Heater, please plug the AC 24V cable into the Camera’s Power Connector to power up the Camera instead. Heater can only be powered by the 24VAC adapter. 2. For ICA-H652, the Heater can be powered by the 24VAC adapter or 60-watt PSE device. Step 15 Set your computer’s IP address to 192.168.0.x, where x is a number between 1 and 253 (except 20 which is being used for t ...

If you have any other question, please contact the dealer where you purchased this product or you can contact PLANET directly at the following email: Email address: [email protected] ...