GeoVision GV-LPR Quick Setup Manual

Text of the manual

Qualified Image Criteria

2010/11 English © 2010 GeoVision, Inc. All rights reserved. All GeoVision Products are manufactured in Taiwan. www.cctvireland.ie Lo-Call 1890 866 900 [email protected] GeoVision GV-LPR Licence Place Recognition software Quick Setup Guide

The qualified image examples

To increase the licence plate recognition accuracy, you need to install the LPR camera in the proper way to capture the qualified plate images. When you install the LPR camera, there are certain criteria to meet, including the plate size, the lighting condition and the angle of the camera. In this document, we provide the qualifi

The unqualified image examples

The plate is the hollow-letter type: Example Try to: Reduce the illumination. The image is unclear: Example Try to: Adjust the focus or the shutter speed of the camera. www.cctvireland.ie Lo-Call 1890 866 900 [email protected]

The image is overexposed:

Example Try to: Reduce the illumination, or adjust the angle or the setup direction of the camera. The image is interfered by the headlight: Example Try to: Use the professional LPR camera to avoid the headlight interference. www.cctvireland.ie Lo-Call 1890 866 900 [email protected]

The plate size is too small:

Example Try to: Zoom in the camera or reduce the distance between the camera and the vehicle. You should capture and fill the image with a full width of vehicle. The plate size is too big: Example Try to: Zoom out the camera or enlarge the distance between the camera and the vehicle. You should capture and fill the image with a f

The image contrast is low:

Example Try to: Improve the lighting condition. The plate is slanted: Example Try to: Adjust the camera setup angle and make sure the angle of deviation in the captured license plate is within eight degrees. 8° More than 8° www.cctvireland.ie Lo-Call 1890 866 900 [email protected]

The plate is in shadow:

Example Try to: Avoid placing the camera where it can be subjected to direct sunlight or reflections. Visible shadow edges in the camera view may degrade the recognition accuracy. www.cctvireland.ie Lo-Call 1890 866 900 [email protected]

● Installing the camera in the front (Recommended): Install the camera in

the upper front of the vehicle as shown below. Ensure to install the camera to meet the following conditions. In this way, the height of the captured plate characters would approximately fall between 30 and 35 pixels. ◦ The captured image should be filled with a

Other Security Camera Manuals