Ikelite DS160 Instructions Manual

...

IKELITE DS161 SUBSTROBE............3 Specifications ......................................3 Introduction ..........................................4 Starting Out..........................................4 Strobe Compatibility ............................4 Strobe Power ......................................4 DS160 Substrobe ............... ...

Complies with FCC part 15, subpart B, Section 15.109 for Class “B” Products S p e c i f i c a t i o n s Battery Pack ............................................ ....... Li-ion module, 7.4v, 4500mAh Weight .................................................... ....... 2.5 lb (1130g) Size.... ...

photographic and lighting experience to the strobe market. Ikelite Substrobes are designed and built in the USA by Ikelite to suit both the professional and the amateur photographer. The purpose of a strobe is to illuminate the subject and assist the camera ...

DS160 SUBSTROBE The Ikelite DS160 strobe combines high intensity output and wide coverage angle in a compact, versatile design. This strobe features 160 watt-sec. intensity and covers a full 100° using the diffuser. Special soft-lite reflector provides rich reds, oranges, and warmer flesh tones. The Ikelite DS160 strobe is ...

Turn the strobe OFF, and place the strobe face down on a flat surface. Slide the locking lever out by either grasping the sides of the lever and pulling it out OR use your thumb to apply slight pressure to the top of the lever and slide it out. Flip the lever up and then rotate the lever counter-clockwise 90°. The internal spring automati ...

UNLOCK INDPLS IN U.S.A. UNLOCK Pull Out Flip Up Rotate OPENING AND CLOSING (CONT.) ...

#BCW-306-125-01-03N, which has a green power LED and yellow charge LED on the charger front. CHARGING THE Li-ion PACK WITH NiMH CHARGER When recharging the Li-on Pack with an older NiMH charger, a solid red LED indicates the Pack is charging. When the LED is NOT lit, the Pack is fully charged. 8 The 4060.1 DS1 ...

Flash Diffuser Installation Post Diffuser Cut-outs DS160 Strobe Diffuser Retention Tab Lanyard Holes USING THE DIFFUSER The white diffuser can be secured to the front of the DS160 strobe when softer lighting or a coverage angle of 100° is desired. The diffuser reduces the DS160’s light intensity by one full f-stop. DIFFUSER INSTALL ...

Ikelite offers several arm choices compatible with the DS160. The arm and strobe mount are NOT supplied with the strobe. For additional information go to www.ikelite.com Caution: Ikelite arm systems are designed for underwater use. Be careful when transporting the system above water since some camera trays and arm adjustments may be un ...