HPM LFS0110WBL Instruction Manual

Cat. No. LFS0110WBL, LFS0130WBL Fig. 2 Introduction This floodlight incorporates an automatic passive infrared (PIR) sensor. The sensor continuously scans a preset operating zone and immediately switches the floodlight ON when it detects movement from people and animals. It can be used to illuminate pathways, steps, patios, porches or other areas that require lighting for reasons of safety, convenience or ...

Blue wire to neutral N White wire to light Green-yellow to light Green-yellow to earth Brown wire to switch L Setting the controls With floodlight fully installed by electrician and power on 1. Turn the LUX control knob to light ( ) position, turn the wall switch on and wait 30 seconds for the control circuit to stabilise. Ensure the TIME control knob is set at minimum (-).The lamp on the sensor light will now switch on and will remain ...

Adjusting the duration time The length of time that the unit remains switched on after activation can be adjusted from 10±5 seconds to 4±1 minutes. Rotating the TIME knob anticlockwise from (+) to(-) reduces the duration time. Note: Once the light has been triggered by the PIR sensor any subsequent detection will start the timed period again from the beginning. Adjusting the LUX control level The LUX control module has a built- ...

2. An IP rating of IP44 is generally considered suitable for external walls with supplementary protection such as overhanging eaves. 3. The IP rating of this product is only valid when installed on a flat and non-porous surface. Additional sealing may be required for irregular surfaces. 4. The fixing screws on this product should be tightened to a maximum tor ...