Key Digital KD-IP120TX Operating Instructions Manual

develops and manufactures high quality, cutting-edge technology solutions for virtually all applications where high-end video and control are important. Key Digital® is at the forefront of the video industry for Home Theater Retailers, Custom Installers, System Integrators, Broadcasters, Manufacture ...

system where video inputs and video outputs may be scaled to fit any installation. Add up to 1024 Tx units and an unlimited number of Rx units for the ultimate custom video solution. Key Features ›› HDMI Pass-through: Tx unit support HDMI Pass-through to receive ...

**Please be aware that IP Addresses cannot clash for all KD-IP120 Units. Please keep track of IP Address for setup** »» b. Assign a Group ID for every Tx unit and number it as source input number **Please be aware that Group ID’s cannot clash for Tx Units. Each Tx Unit must have a unique Group I ...

Connections All connections to the KD-IP120 are found on the rear panel of the unit. Refer to the illustrations below for port assignments while making connections. KD-IP120 Tx Unit - Back Panel Operation A. Input Connections ›› HDMI Input »» Compatible with DVI1.0/HDMI1.3b/HDCP1.x »» Video Resolution supports up to 1080p@60 (2 ...

A. Input Connections ›› Ethernet »» Compatible with CAT5e/6 UTP/STP cable »» Supports up to 400ft extension over CAT5e/6 UTP/STP cable »» Video Resolution supports up to 1080p@60 (2.25Gbps) »» Audio format support up to 2ch PCM at 44.1/48kHz »» A/V Stream Bitrate is up to 15Mbps B. Output Connections ...

setup instructions, please refer to the “Quick Setup Guide” section. Creating and saving a new system file: To create a new system file after configuring all Tx and Rx units, first, click “Network Scan” while connected to the IP Video network (I ...

control of the matrix system (Indicator E). To switch sources, select a Output first then select an Input. Web Interface The KD-IP120 Web Interface provides basic configuration settings for operation. To use the Web Interface, connect a PC to the Smart Ma ...

›› Network Setup is where the IP Addresss, Subnet Mask, and Router IP Address may be changed when. Click Apply to save changes ›› Multicast Setup is where the Group ID may be changed and IGMP may be enabled or disabled. **Please be aware that Group ID’s cannot clash for Tx Units. Each Tx Unit must have a unique Group ID ...

»» Enclosure: Black Metal »» Rack Mount: 1U, full rack-width (rack ears included) »» Product (Each): 4.74” x 3.11” x 1.16”, Weight: 0.6 lbs »» Packaging: 6.2” x 4.2” x 3.7”; Weight 2 lbs System Examples Smart Network Switch 18 Displays HDMI Master Controller Enterprise AV [ HD Over IP ] GUI ...

1. Connect all cables before providing power to the unit. 2. Test for proper operation before securing unit behind walls or in hard to access spaces. 3. If installing the unit into wall or mounting bracket into sheet-rock, provide proper screw support with bolts or sheet-rock anchors. Safety Instructions: Please be sure ...