HP MSM710 Quick Start Manual

Text of HP MSM710 Quick Start Manual

MSM710 Controller Quickstart

This Quickstart applies to both the MSM710 Access Controller (J9328A) and the MSM710 Mobility Controller (J9325A). This Quickstart introduces the HP ProCurve Networking MSM710 Controller and shows you how to get started using it. After following the directions in this Quickstart, see the MSM7xx Controllers Management and Configuration Guide available at: www.hp.com/go/procurve/manuals. Hardware overview Package contents MSM7
MSM710 Controller Quickstart 2 HP ProCurve Networking Status lights All three status lights are located on the front panel. Important information to read before installation Warning: PROFESSIONAL INSTALLATION REQUIRED Prior to installing or using this device, consult with a professional installer trained in RF installation and knowledgeable in local regulations including building and wiring codes, safety, channel, power, indoor/outdoor restrictions, and li
MSM710 Controller Quickstart 3 HP ProCurve Networking Initial configuration This procedure describes how to perform the initial configuration of a factory-default MSM710, enabling you to establish a wired connection through the MSM710 to the Internet. The MSM710 is managed via its web-based management tool using at least Microsoft Internet Explorer 7/8 or Mozilla Firefox 3.x. Note: Since the provided power supply is the recommended way of powering the MSM7
MSM710 Controller Quickstart 4 HP ProCurve Networking E. Configure system time settings Accurate time is critical for correct operation of the MSM710, as the time configured on the MSM710 is used on all controlled APs. Configure system time settings as follows: 1. In the management tool, select Controller >> Management > System time. 2. Set the timezone and DST as appropriate for your region. 3. If the MSM710 will be connected to the Internet, select Set d
MSM710 Controller Quickstart 5 HP ProCurve Networking 2. In the Assigned by DHCP server box verify that an IP address is assigned. 3. If your Internet service provider or network administrator requires a different configuration, for example a static IP address assignment, select Controller >> Network > Ports > Internet port and choose another option in the Assign IP address via box. Select the corresponding Configure button and configure the needed setting
MSM710 Controller Quickstart 6 HP ProCurve Networking Note: This procedure assumes that the MSM710 and the MSM AP are on the same subnet (L2 connected). For full discovery information, including configuring discovery when the MSM710 and the MSM AP are separated by a router (L3 connected), see Discovery of controlled APs in the MSM7xx Controllers Management and Configuration Guide. By default, MSM APs are configured to obtain an IP address via DHCP. Therefo

HP Controller Owners Instructions: