TRENDnet TI-PG80 Quick Installation Manual

ŸRemovable terminal block ŸDIN-rail mount ŸWall mount plates 1. Before You Start ŸExisting network ŸPower source (TI-S24048) 2. Quick Reference TV-IP310PI TV-IP322WI ...

ŸThe TI-PG80 can be placed on a desktop, wall, or mounted to a DIN-rail. 1. Attach the DIN-rail mount bracket to the switch. 2. Position the switch in front of the DIN-rail and hook the mount bracket over the top of the rail. Mounting the switch Releasing the switch DIN-rail Mounting Instructions 3. Rotate the switch downward ...

Wall Mounting Instructions 2. Mount the switch. ŸTurn off the power before connecting any module or wire. The correct power supply voltage (48 - 56 V DC) is listed on the product label. Check the voltage of your power source to make sure that you are using the correct part. Do NOT use voltage greater than 48 ...

confirm the connections are established. Your installation is completed. 1. Connect the power supply (sold separately) to the included terminal block (as shown below) and secure with the screws. Applying Power 2. Attach the terminal block to the unit, secure with the included screw ...

EMC Directive 2004/108/EC RoHS Directive 2011/65/EU REACH Regulation (EC) No. 1907/2006 TRENDnet hereby declare that the product is in compliance with the essential requirements and other relevant provisions under our sole responsibility. This product is herewith confirmed to comply with the Directives. Product In ...

and service. Specific warranty periods are listed on each of the respective product pages on the TRENDnet website. Garantie Limitée TRENDnet garantit ses produits contre les problèmes de matériel ou de fabrication, dans des conditions normales d'u ...

FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical an electronic products must not be disposed of w ...