Daviscomms MTD1000 Startup Manual

2. Setting up as a tracking device 3. Installation of Microsoft.NET ver 1.1 4. Installation steps for MTS application 5. Setting up as a modem 6. Google Earth Plus installation 7. Appendix 1. Hardware setup of the tracking device 2. Determine if you have the RS232 port available on your PC Fig.1 Fig.2 Using serial communication Connect the communication cable to the RS232 port of your PC By default, it is recommended to use the communication cable to interface from the tracking device/modem to your PC. It is not required t ...

The communication device that processes the GSM/GPRS and GPS functions. c. GPS antenna (SMA connector) for the MTD1000 device The receiver component required to receive GPS data to the MTD1000 device for a location fix. b. Power Adapter 1X Power adaptor (100 – 240V~ 50/60Hz 650mA Max) for the MTD1000 tracking device d. Li- Polymer battery for MTD1000 An alternative solution to power up the MTD1000 without a power adaptor up to 24 hours. Voltage/ current specification: (3.7V/ 780mAh) e. Communications cable The cable that interfaces from the MTD100 ...

6. Google Earth Plus installation Communications cable to PC Power adaptor Modem Step 2 Step 1 Insert the SIM card (Not included in the package) Connect the Li-Polymer Place the back cover to the modem *Important: Take note of the SIM card number of the modem Modem Li-Polymer battery SIM card Click “Run” to install the Google Earth installation program. Click “Install”. Step 1 Step 2 Connect the power adaptor and power it up Connect the communications cable from the modem to your PC Purchase the Google earth plus license key from https://registration.k ...

and check on “Include this location in the search”. Click “Browse” Step 4 Step 3 Click “Next” Click “Continue Anyway” Step 5 Step 6 Locate the folder “Winxp V1.5” and click “OK” 500206R01 ...

program Uncheck all boxes except launch “Google Earth” and click “Finish” to complete the installation. Important*: When Google earth is launched, go to Help-> Google Earth Plus License and enter the license key which you have already purchased online from step 31 and click activate. Close the Google earth application Step 3 Step 4 Step 5 Step 6 Open the PTS program Select “System” and click on “SMS Channel” Key in the comport number of the e.g. COM1 if using the serial communications cable. Important*: Refer to page 7 ...

When the red LED is lighted up, it means the unit is charging up the Li-polymer battery When the red LED is not lighted up, it means the Lithium polymer battery is fully charged or the Li- polymer battery is not connected to the battery and charging is not active. When the green LED is lighted up, it means the unit does not detect the presence of a SIM card. When the green LED is flashing slowly, it means the unit has detected the presence of the SIM card and has registered to the GSM network When the green LED is flashing qui ...

Step 8 Check “Launch MTD1000 PTS 3.00” and click “Finish” Step 9 Select “Device” and click on “Serial port” 500206R01 ...