Dell S520 Setup Manual

Text of the manual

Dell™ | Interactive Projector

S520 Laser Touch Setup Guide Příručka pro zprovoznění laserového ukazovátka Opsætningsguide for Laser Touch Laser Touch instelgids Guide d'installation du pointeur laser Laser-kosketusasetusopas Laserberührung-Einrichtungsanleitung Οδηγός εγκατάστασης λέιζερ αφής Laserberührung-Einrichtung

Dell™ | Interactive Projector

S520 Laser Touch Setup Guide S520 Laser Touch QSC_A02-EMEA.book Page 1 Wednesday, May 14, 2014 6:56 PM

NOTE: A NOTE indicates important information that helps you make better use of your

projector. __________________ Information in this document is subject to change without notice. © 2014 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trad

Set Up Laser Touch on Your Projector

3 NOTE: You computer must have the following minimum system requirements: Operating System: • Windows XP Professional service pack 3 32-bit, Windows 7 32-bit/64-bit, and Windows 8 32-bit/64-bit • Windows .NET Framework 4.0 installation is required (You can download it from the Microsoft site) • MacOS 10.6 and above

Set Up Laser Touch on Your Projector

4 Part B: Mount the Projector 2 Install the wall mount and the projector. NOTE: The wall mount is shipped with your projector. Please refer "wall mount installation instructions". NOTE: Project at 87" for a maximum image size projection or ~84" if you would like to leave a border around the projector image for optimal t

Set Up Laser Touch on Your Projector

5 Part D: Connect Necessary Cables 4 Connect power, video, Mini USB, and DC- to-DC cables to the projector. 5 Connect the power cable to the power outlet. 6 Connect the DC-to-DC cable to the laser curtain kit. 2m DC-to-DC cable S520 Laser Touch QSC_A02-EMEA.book Page 5 Wednesday, May 14, 2014 6:56 PM

Set Up Laser Touch on Your Projector

6 7 Connect the VGA cable to your computer. NOTE: You can also project the image through VGA-B and HDMI. Press the left button on your control panel for auto searching and selecting the correct input source. 8 Connect the Mini USB cable to your computer. 9 Power on the projector by pressing the power button on the remote

Other Projector Manuals