Digital Equipment DECserver 900TM Installation Manual

chronous devices, including terminals, printers, modems, or PCs to an Ethernet local area network (LAN). It operates in a DEChub 900 MultiSwitch or as a standa- lone access server. The DECserver 900TM is configured with 32 MJ8 (RJ-45) con- nectors, and ...

DEC, DECconnect, DEChub, DEChub ONE, DECserver, Digital, MultiSwitch, ULTRIX, OpenVMS, and the Digital logo. UNIX is a trademark of UNIX System Laboratories, Inc. EK–DSRVZ–IN. A01 August 1993 The information in this document is subject to change without notice a ...

1) Power LED. Lights when the module has power. 2) Module OK LED. Lights when the module passes self- test. Flashes when a non-fatal error occurs on self-test. If ...

hub. The DECserver 900TM has a built-in hot-swap switch that allows quick and easy power-on installation and removal. Install the module into the DEChub 900 MultiSwitch. Installing the Module into a DEChub 900 MultiSwitch � 4 ...

� DECserver 900TM 5 a. With power on in the DEChub, verify that the Power LED is on. b. Verify that the Module OK L ...

6 DECserver 900TM LKG–8091-93I If you using a Flash RAM card for loading the operational software, perform the following: a. The Digital label should be on the same side as ...

DECserver 900TM 7 � Remove the module from the DEChub. � Disconnect the port connector cables from the module. a. ...

900TM supported line protocols. For more information about cabling and configuring of local area networks (LANs) and using DECconnect system products, refer to the DECconnect System Planning and Configuration Guide. ����� �� � ...

�������� ��� ��� ...

the software to support the pin signals indicated in Table 3. � � � � � � � � ��� ��� ��� ���� ��� ��� �� ���� ��� ��� ��� ��� �� �� ���� ...