Ellington COL72BP6 Installation Manual

Text of the manual

Table of Contents:

Safety Tips. pg. 1 Unpacking Your Fan. pg. 2 Parts Inventory. pg. 2 Installation Preparation. pg. 3 Hanging Bracket Installation. pg. 3 Fan Assembly. pgs. 4 - 5 Wiring. pg. 6 Canopy Assembly. pg. 7 Blade Assembly. pg. 7 Switch Housing Assembly. pg. 8 Automated Learning Process./ Activating Code. pgs. 8 - 9 Testing Your Fan. pg. 9 Troubl

WARNING: To reduce the risk of electrical shock, turn off the electricity to the fan at the main fuse box or circuit panel

before you begin the fan installation or before servicing the fan or installing accessories. 1. READ ALL INSTRUCTIONS AND SAFETY INFORMATION CAREFULLY BEFORE INSTALLING YOUR FAN AND SAVE THESE INSTRUCTIONS. C

1. Unpacking Your Fan.

Carefully open the packaging. Remove items from Styrofoam inserts. Remove motor housing and place on carpet or Styrofoam to avoid damage to finish. Do not discard fan carton or Styrofoam inserts should this fan need to be returned for repairs. Check against parts inventory that all parts have been included. 2. Parts Inventory. a

3. Installation Preparation.

ON OFF ON OFF 4. Hanging Bracket Installation. Turn off circuit breakers to current fixture from breaker panel and be sure operating light switch is turned to the OFF position. WARNING: Failure to disconnect power supply prior to installation may result in serious injury. Remove existing fixture. WARNING: WARNING: To reduc

5. Fan Assembly.

If you wish to extend the hanging length of your fan, you must remove the hanging ball from the downrod provided to use with an extended downrod (sold separately). [If you wish to use the downrod provided, please proceed to instructions following the dotted line below.] To remove hanging ball, loosen set screw on hanging ball, lower h

hanging ball slot

hanging bracket tab motor housing safety cable wood screw and washer safety cable loop wood ceiling joist canopy 5. Fan Assembly. (cont.) With the hanging bracket secured to the outlet box and able to support the fan, you are now ready to hang your fan. Grab the fan firmly with two hands. Slide downrod through opening in hanging brac

CAUTION: Be sure outlet box is properly grounded or that

a ground wire (GREEN or Bare) is present. Make sure all electrical connections comply with Local Codes or Ordinances and the National Electrical Code. If you are unfamiliar with electrical wiring or if the house/building wires are different colors than those referred to below, please

7. Canopy Assembly.

8. Blade Assembly. Locate 2 screws on underside of hanging bracket and remove screw closest to the open end of the hanging bracket. Partially loosen the other screw. Lift canopy to hanging bracket. Place rounded part of slotted hole in canopy over loosened screw in hanging bracket and push up. Twist canopy to lock. Re-insert screw

Other Fan Manuals