Casablanca 54022 Installation Manual

Your Installation Ceiling Bracket Installation Ladder PAG E 3 Tools Needed Wiring Canopy Maintenance & Cleaning Troubleshooting Downrod Preparation ? ? ? PAG E 11 PAG E 17 PAG E 13 PAG E 14 PAG E 12 Blades Switch Housing Light Kit Con ...

Know your wiring If you are unfamiliar with wiring, use a qualiied electrician. You may need a friend to help you. Check box to see fan weight Assess location 30 inches from blade tip to nearest wall or ob ...

Tools Needed Ladder Power Drill (optional) 9/64” Drill Bit (optional) Screwdrivers Pliers Wire Strippers If mounting to a support structure, you will also need these tools. ...

If you have an angled ceiling: 1. You will need a longer downrod (sold separately). 2. If your ceiling angle is greater than 34°, you will also need an Angled Mounting Kit (sold separately). Guide Touches BOTH Ceiling & Wall S I T U A T I O N 1 Guide Touches Wa ...

OFF Make sure all four (4) bumpers are still attached. For angled ceilings, point opening toward peak. Refer to warning w.1 on pg. 2 To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers ...

Preparation D I S C A R D K E E P ! Remove the shipping blocks from the motor. Save the ive screws. They will be needed for blade iron installation. 1.888.227.2178 www.CasablancaFanCo.com Time Saver Tip: Get a helper to insert grommets, found in the hardware bag, into the ...

higher Shorter Downrod for fans installed close to ceiling Standard Downrod for ceilings 8-10’ high Option 1 Option 2 Option 3 skip to next page If you need a different downrod length follow thes ...

Remove the pre-installed setscrew so that the downrod can be inserted. Hand tighten the downrod (at least 4-5 full turns) until it stops. The wires can be cut, but leave at least 8” extending from the top of the downrod. Downrod (continued) 8” 3/8” Tighten the set ...

Downrod (continued) DO NOT PICK THE FAN UP BY THE CANOPY OR WIRES. Place the downrod ball into the slot in the ceiling bracket. Put the wires and downrod through the canopy. Let the canopy sit loosely on top of the fan. ...

into the outlet box. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box. Refer to CAUTION c.1 on pg. 2 F R O M F A N F R O M C E I L I N G B R A C ...