ClearView ip-73 Quick Start Manual

This quick start guide is designed to be a reference tool for your system. Please keep this start guide well for future reference. Please open the accessory bag to check the items one by one in accordance with the list below. Contact your local retailer ASAP if something is missing or damaged in the bag. ...

The grounding studs of the product are recommended to be grounded to further enhance the reliability of the camera. 6. Daily Maintenance Please shut down the device and then unplug the power cable before you begin daily maintenance work. Do not touch the CCD (CMOS) optic componen ...

� ��������� ................................................................................................................................. 1 ��� ���������� ............................................................................................................. 1 ��� ���� ...

1-1. Figure 1-1 Multiple-function combination cable Please refer to the following sheet for detailed information. No. Port Name Connector Note 4 LAN Network port Ethernet To ...

Figure 1-3. Figure 1-2 Dimension illustration 1 Figure 1-3 Dimension illustration 2 ...

of the camera. Please follow the steps listed below to install the device. Please refer to Figure 2-1 for ...

Note This series product supports two cable exits. One is from the bottom and the other is from the side. Please refer to the following figure for cable exit from the side information. Figure 2-3 Device installation illustration 3 Please earth the GND port of the device to enhance the device reliability. The GN ...

��� �������������������������������������������� Important Please use RESET button when device is running. Step1 Please refer to step1 and step2 in chapter 2.1to loose the dome body. Push a little bit; you can take the ...

3.1 Overview Quick configuration tool can search current IP address, modify IP address. At the same time, you can use it to upgrade the device. Please note the tool only applies to the IP addresses in the same segment. 3.2 Operation Double click the “ConfigTools.exe” icon, you can see an interface is shown as in Figure 3-1. I ...