Conrad VC 350E Operating Instructions Manual

Digital Multimeter VC 350E Item-No.: 12 55 12 N O T I C E D ´ E M P L O I Multimètre numérique VC 350E No de commande: 12 55 12 B E D I E N U N G S A N L E I T U N G Digitalmultimeter VC 350E Best.-Nr.: 12 55 12 G E B R U I K S A A N W I J Z I N G Digitale Multimeter VC 350E Best.-Nr.: 12 55 12 NL D F GB Pagina ...

• Measurement of frequency up to 2 MHz max. • Measurement of temperature from -40°C to +1000°C max., -40°F to +1999°F max. • Measurement in damp areas, outside, or in unfavourable envi- ronmental conditions, is not permitted. Unfavourable environ- mental conditions include: - wetness or excessive air humidit ...

are themselves fused at 16 A or in which no voltage greater than 250 VDC/VAC rms or powers greater than 4000 VA can arise. The measuring device must not be used in installations of overvoltage category III in accordance with IEC 664. The measu- ring device and instrument leads are not prote ...

removed from the test object. • Before each measurement check your measuring device and instrument leads for damage. • Only use the instrument leads which are enclosed with the mea- suring device for measurement. No others may be used. • To avoid electric shock, care should be taken th ...

ment function. 2d Blue button for switching from the measurement of DC to AC units (while measuring V, uA, mA and A) or also, in the switch position " / ", from diode test to acoustic conti- nuity checking. 2e REC With this button the Auto-Hold function "A-H" and the minimum (= MIN) and maximum (= M ...

open! Danger to life! Do not leave used batteries in the measuring instrument, becau- se even leak-proof batteries can corrode and thereby release che- micals, which are both damaging to health and can destroy the battery compartment. Used batteries are to be regarded as waste requirin ...

measuring device, and can endanger the user. 5.4 Positioning the measuring instrument (sloping position) or position of use Always operate the multimeter so that the liquid crystal display (LCD) can be read and the digital display is facing upwards. There is a fold-out bracket on ...

button A/TEMP°F = DC and AC current measurements up to 20 A max. or temperature measurements in °F, Auto-Range and manual range selection possible; Switch to temperature measurements with yellow button c) 20A socket For DC or AC current measurements up to 20 A max. (!), the red measuring lead must be plugge ...

point, the small display returns to "0000", while the set refe- rence value remains visible in the main display. D) COMP (= Comparison) In this sub-function, a high/low comparison can be carried out, in which the highest and lowest stored reference value can be com- pared with the present measu ...

the test probes the point to be measured, the value of which is to be set as the upper limit (Hi). Press the button " REL" until the desired value is displayed in the main display. At the same time the rightmost digit remains flashing. Now remove the test probes from the p ...