Consew 226R Operating Instructions Manual

~P. (586) 948-6070 E-Mail:[email protected] WebSite:www.mjfoleyco.com ...

2 Breaking-in & Direction of rotation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 2 Oiling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 3 Needle. . . . . . ...

Before setting up the machine on the table, attach the relative parts to the table. (1) Stand and treadle (2) Motor (3)Oil pan (4) Hinge (5) Machine head (6) Knee lifter (7) V belt (8) Bobbin winder (9) Cotton stand (10) Prop Fig. 1 BREAKING-IN & DIRECTION OF ROTATION To assure durability and trouble-free operation, it is im ...

oiled at every spot requiring lubrication. The arrows on the following illustration indicate these spots. (Fig. 2 - Fig. 6) NOTE: During the breaking-in period a new machine should be oiled more fre- quently. fig. 2 Fig. 3 t (Without Alphabet) marked for Oiling points ...

to be used should be determined by the size of the thread, which must pass free- ly through the eye of the needle. HOWTO ATTACHTHE NEEDLE 1. Turn the machine pulley over toward you until the needle bar

1. Push a bobbin on the bobbin winder spindle@)as far as it will go. 2. Pass the thread from the thread stand downward through the eye(!) in the tension bracket, then between and around the back of the tension diSC@. 3. Bring the thread forward toward the bobbin and wind from below in clock- wise direction se ...

1. Lift the needle bar to its highest point, place the feed dog at this side in its travel turning the machine pulley, and open the slide plate (A, Fig. 2). 2. Pass left hand under table into opening on drip pan. With left thumb and index finger, open the hinged latch (C, Fig. 4). And pull bobbin case and bob- bin from rot ...

1. Raise the needle bar to its highest point and lead the thread from the thread stand the following order: From the thread stand lead the thread from back to front through the lower guide hole in pineDon top of the machine arm, then again from right to left through the upper guide hole in this pin. Pass thread in weaving fa ...

equal so as to lock both threads in the center of the material. ~ _"uu Perfect stitching If the tension on either thread is stronger than on the other, imperfect stitch- ing will be the result. If the tension on the upper thread is greater than t ...