Argox OS-214plus Operation & User’s Manual

OS-214plus/OS-2140D/ OS-2140/OS-2140Z/ OS-2140DZ User’s Manual Website: http://www.argox.com Ribbon & Media Installation video all-guides com ...

intended solely for the information and use of parties operating and maintaining the equipment described herein. Such proprietary information may not be used, reproduced, or disclosed to any other parties for any other purpose without the expressed written permission of Argox Information Co., Ltd. Product Improvements Continuous improvement of products ...

product, even if Argox Information Co., Ltd. has been advised of the possibility of such damages. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Safety INDUSTRY CANADA NOTICE: This device complies with Industry Canada ICES-003 class A requirements. Cet equipement ...

Safety ........................................................................................ II Getting Started .................................................................. 5 Unpacking .................................................................................. 5 Package Contents ................................................................... 6 Connecting the Power Supply............................................. ...

Caring for Your Printer ................................................... 52 Cleaning ................................................................................... 52 Media Sensor ....................................................................... 52 Thermal Print Head .............................................................. 52 Replacing the ...

OS-214plus/OS-2140D/OS-2140/OS-2140Z/OS-2140DZ desktop barcode printers. This manual will help you get to know your new printer. There are two parts to this manual, an operation guide and related information. The operation guide is illustrated to help you quickly become familiar with the printer. The related information includes troubleshooting, maintenance and technical information for your reference ...

 USB Cable  0.5” ID Core for Ribbon  Media Holder ...

Connect the power supply as below. WARNING! Do not operate the printer and power supply in an area where they can get wet. Make sure the power switch is in the "O" position. 1. Insert the barrel connector of the power supply into the power jack on the back of the printer. Note the location of the power jack for different models in the diagrams below. 2. Insert the separate power cord into the power supply. 3. Plug the other e ...

The illustrations that follow describe the printer’s parts, features, controls, and indicators. Parts and Features OS-214plus/OS-2140D/OS-2140/OS-2140Z/OS-2140DZ Top Cover Power Switch H Cover Power Indicator Ready Indicator Feed Button ...

Release Levers Ribbon module (not included with OS-2140D) all-guides com ...

The printer’s controls and indicators are shown in the diagram below. The following table explains control and indicator functions. Top Cover Power Indicator Ready Indicator Feed Button Power Switch ...

 Off: turns off power Note: Turn power off before connecting or disconnecting cables Power Indicator  Green light shows the power-on  Light off shows the power-off  Blinking light indicates error has occurred Ready Indicator  Green shows printer is ready to operate  Blinking light indicates printer is paused or data transferring  Seagull driver status monito ...

This section describes how to load ribbon and media in the OS Series printer. Loading Ribbon Note: This section does not apply to direct thermal printing. 1. Lift the top cover to expose the media compartment. 2. Unlatch the print head module by pushing the two white release levers on the sides toward the rear. 3. Turn over the print head module to expose the ribbon supply holder. ...

Release Lever Ribbon Supply Holder all-guides com ...

and the bare core. 5. Attach the edge of the ribbon on the bare core and wind it a little bit onto the core. 6. Insert the ribbon roll into the supply holder. (First snap in the left side and then the right side.) Ribbon Supply Holder Ribbon Roll Bare Core ...

core into the pick-up holder. (First snap in the left side, and then the right side.) Ribbon Pick-up Holder Bare Core ...

ribbon is tightly wound. 9. Press down the print head module firmly until you hear a snap. Wheel Print Head Module ...

cutter.  Standard mode allows you to collect each label freely.  Cutter mode automatically cuts the label after it prints. Standard Mode 1. Lift the top cover to expose the media compartment. ...