Asko D5424 Operating Instructions Manual

Text of Asko D5424 Operating Instructions Manual

Thank you for choosing this quality product from ASKO.

We hope it will meet your expectations and fulfil your needs for many years to come. Scandinavian design combines clean lines, everyday functionality and high quality. These are key characteristics of all our products and the reason they are greatly appreciated throughout the world. To get the most from your new dishwasher, we recommend that you read the operating instructions before usi

BEFORE WASHING FOR THE FIRST TIME

5 LOADING THE DISHWASHER 7 USING THE DISHWASHER 9 SETTINGS 11 CARE AND CLEANING 13 TROUBLESHOOTING 16 TECHNICAL INFORMATION 18 INSTALLATION 23 SERVICE 24 PROGRAM CHART 25 YOUR NOTES FRONT PANEL The panel is fitted with touch buttons with audible feedback (see the chapter Settings). PROG START STOP 2 1 8 9 3 4 5 6 10 12 11 13 14 7 1 Program selector 2 Daily wash 3 Heavy wash 4

• Read the operating instructions and keep them in a safe place!

• Never use the dishwasher for any purpose other than that specified in these operating instructions. • Do not load the dishwasher door or dishwasher baskets with anything other than dishes. • Never leave the dishwasher door open as someone may trip on it. • Use only dishwasher detergent! • Place knives and other sharp items so that they cannot harm any

• When the dishwasher has reached the end of its service life

and is to be disposed of, it should immediately be made unusable. Pull out the power cable and cut it as short as possible. • The dishwasher is manufactured and labelled for recycling. • Contact your local authority for information about where and how your dishwasher should be correctly recycled. BEFORE WASHING FOR THE FIRST TIME CHECKING WATER HARDNESS Contact the local water uti

LOADING THE DISHWASHER

ECONOMIC DISHWASHING Run programs only with a full load Wait to run a program until the dishwasher is full. This way you save energy. Use the Rinse & Hold program to rinse the dishes if there are any unpleasant odours while you wait for the dishwasher to become fully loaded. Run programs at a lower temperature If the dishes are only slightly dirty, you can select a lower temperature with certain programs. See also the section Selecti

Place cutlery with the handles facing down, except for knives, and

spread them out as much as possible. Ensure that spoons do not stack inside each other. The cutlery basket is best placed in the middle at the front of the lower basket to best utilise dishwashing performance from the unique spray nozzle (Power Zone™ Cutlery), which is intended for the cutlery basket. NOTE! Do not place cutlery made of different materials, such as silver an

USING THE DISHWASHER

ADD DETERGENT 1 Prewash detergent compartment 2 Main wash detergent compartment Detergent is added according to water hardness. Follow the instructions on the detergent packaging. Too much detergent can result in less effective dishwashing and also entails greater environmental impact. Add the detergent to the detergent compartment. There is one compartment for the prewash and one for the main wash. If tablets are not used, add a small

Asko D5424 You can vary the temperature as shown below:

55 °C / 70 °C Heavy wash: 50 °C / 65 °C Normal program: 60 °C / 65 °C Daily wash: 30 °C / 60 °C Quick wash: 55 °C / 60 °C Eco wash: Long dry A higher temperature in the final rinse and a longer drying phase improves the drying result if you activate the Long dry option. This causes a slight increase in energy consumption. If you want a program with Short dry, press so that the field next to the button

DO AS FOLLOWS TO OPEN THE SETTINGS MENU:

Turn off the dishwasher using the main power switch. Wait about five seconds. 1. Then press the main power switch again. Wait until the numbers appear in the right-hand display before continuing to the next step. 2. Within five seconds, press and hold the Program selector (wait for the audible signal confirming the button press) and then immediately press the Long dry button without releasing the Program se

This sound is used to confirm each button press.

Operation volume (Off) (Low) (High) Press Start to save the setting value and continue to the next setting. For adjusting the contrast of the display. LCD contrast (Low) (High) Press Start to save the setting value and continue to the next setting. Rinse aid dosage setting. Rinse aid (Off) (Low dosage) (High dosage) Press Start to exit the settings menu. 10

CARE AND CLEANING

COARSE FILTER The coarse filter traps larger food particles, which cannot get past the drainage pump. Empty the coarse filter as necessary. 1 Lift the coarse filter by the handle. 2 Empty the coarse filter. Remember to replace it! ������ ������ FINE FILTER Debris that collects on the fine filter is automatically rinsed away during each wash. However, the fine filter and its pipe section should be cleaned a couple o

Asko D5424 1 Pull the lower spray arm straight up to release it.

2 Remove any debris using a needle or the like. The spray arms also have holes underneath. UPPER SPRAY ARM The upper basket must be removed before the upper spray arm can be released. 1 Pull out the upper basket and turn the basket catch on each runner outwards (see illustration). The basket can now be removed. 2 Loosen the upper spray arm in the same manner as the lower spray arm and clean it. DOOR Whe

Type of fault

Display Call the service division. Overfilling See "Water remains in the dishwasher" in the table below. Water outlet fault Check that the water tap is on. Water inlet fault Check whether dishwasher inlet hose is connected to a pressure limiting valve (some pressure limiting valves may restrict the supply of water to the dishwasher). Turn off the water tap and call the service division. Inlet valve leakage Turn off the

Check that the dishes are placed securely. Spin

the spray arms to make sure they can rotate. The dishes are not correctly placed or the spray arms are not rotating. Rattling sound when dishwashing. Press and hold Start until the display flashes three times with the remaining time. The Start start button has not been pressed for long enough. The dishwasher does not start. Check. The door is not properly closed. Check. A fuse/c

You have pressed the touch buttons too soon Wait a moment then try again.

after opening the door. The touch buttons do not react when pressed. Clean with a dry or slightly damp cloth. Dirt on the touch buttons. See the section Settings. Child lock (button lock) activated. 15

Asko D5424 INFORMATION FOR TEST INSTITUTE

Energy labelling AS/NZS 2007 Australian standard: 14 Number of place settings: Normal program; Low temperature, Short dry (no options) Dishwashing programs: The door should be opened upon completion of the drying cycle a distance of 35 mm at V. V 2:00 hours:minutes Program time: Cold water 20 °C Connection: IEC 60704-2-3 Test method for noise measurement: Dosages during testing In accordance with AS/NZS

49 kg 1)

Weight: 14 place settings 2) Capacity: 300 - 1000 kPa Water pressure: 0.3–10 kp/cm2 3–100 N/cm2 Electrical connection: See type plate. See type plate. Rated power: 1) Weight can vary due to different specifications. 2) In accordance with standard, AS/NZS 2007. 17

Asko D5424 ������� ������� ���� ��� �� ��������� ������ ��

������� ��� SAFETY INSTRUCTIONS • Connections to electricity, water and drainage must be performed by a qualified professional. • Always follow applicable regulations for water, drainage and electricity. • An incorrect or

SUGGESTED MACHINE INSTALLATIONS

The dishwasher can be installed built-in, completely freestanding or partially built-in. A. Built-in The dishwasher is intended for installation under a worktop. The recess dimensions are illustrated. Holes for wires/cables need not be larger than 38 mm in diameter. Make sure the edges of such holes are even to prevent damage to the drainage and inlet hoses and the power cable. ������� ������� �

When the drainage hose is routed to a connection nipple on the

sink unit's water trap (see illustration 1), please note that the hose must be attached at the same height as the underside of the sink unit, otherwise dishwater from the sink may flow back into the dishwasher. The drainage hose is threaded onto the cone-shaped connection pipe on the sink unit's water trap. The cone-shaped pipe must be cut to an internal diameter of at least

Asko Dishwasher Owners Instructions: