D-Link DGS-3600 Hardware Installation Manual

ii _____________________________________________ Information in this document is subject to change without notice. © 2012 D-Link Corporation. All rights reserved. Reproduction in any manner whatsoever without the written permission of D-Link Corporation is strictly forbidden. Trademarks used in this text: D-Link and the D-LINK logo are trademarks of D-Link Corporation; Microsoft and Window ...

iii FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed an ...

Intended Readers ........................................................................................................................................................................... vi Typographical Conventions .......................................................................................................................................................... vi Notes, Notices, and Cautions ..................................... ...

MIBs ........................................................................................................................................................................................ 26 IP Address Assignment ................................................... ...

vi Intended Readers The xStack® DGS-3600 Series Hardware Installation Guide contains information for setup and management of the Switch. This manual is intended for network managers familiar with network management concepts and terminology. Typographical Conventions Convention Description [ ] In a command line, square brackets indicate an optional entry. For exampl ...

vii Safety Instructions Use the following safety guidelines to ensure your own personal safety and to help protect your system from potential damage. Throughout this safety section, the caution icon ( ) is used to indicate cautions and precautions that need to be reviewed and followed. Safety Cautions To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment o ...

viii • Observe extension cable and power strip ratings. Make sure that the total ampere rating of all products plugged into the extension cable or power strip does not exceed 80 percent of the ampere ratings limit for the extension cable or power strip. • To help protect the system from sudden, transient increases and decreases in electrical power, use a surge suppressor, line conditione ...

ix NOTE: A qualified electrician must perform all connections to DC power and to safety grounds. All electrical wiring must comply with applicable local or national codes and practices. CAUTION: Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if uncert ...

1 Section 1 Introduction Front Panel Components LED Indicators Rear Panel Side Panel The DGS-3600 Gigabit Ethernet switches are members of the D-Link xStack® family. Ranging from 10/100Mbps edge switches to core gigabit switches, the xStack® switch family has been designed to deliver a system with fault tolerance, flexibility, port density, robust security, and maximum throughput, with a ...

2 Features The list of features and protocols below highlights the significant features supported by the xStack® DGS-3600 Series. • Physical Stacking—up to 12 devices, with a bandwidth up to 40G • Virtual Stacking • IEEE 802.3ad Link Aggregation Control Protocol • IEEE 802.1X Port-based and MAC-based Access Control • IEEE 802.1Q VLAN • IEEE 802.1D Spanning Tree, IEEE 802.1w R ...

3 • Port Mirroring, including multiple session support and ability for link aggregation to be set as target port • Network Load Balancing (NLB), a MAC forwarding control for supporting the Microsoft server load balancing application where multiple servers can share the same IP address and MAC address • Per port queue egress bandwidth control • Cable diagnostics • sFlow, including ...

4 • Routing table size--total 12K routing entries, all IPv4/IPv6 static and dynamic routes share these entries: maximum 256 entries for IPv4 static routes, maximum 128 entries for IPv6 static routes, maximum 12K entries for IPv4 dynamic routes, maximum 6K entries for IPv6 dyanmic routes • L3 Forwarding table size—total 8K L3 hardware forwarding entries, both IPv4 and IPv6 forardingt s ...

5 Ports The following table lists the relative ports that are present within each switch: DGS-3612 DGS-3612G DGS-3627 DGS-3627G DGS-3650 Twelve 10/100/1000BASE-T Ports Four SFP Combo Ports One female DCE RS-232 DB-9 console port Twelve 100/1000Mbps SFP Ports Four 1000BASE-T Combo Ports One female DCE RS-232 DB-9 console port Twenty-four 10/100/1000BASE-T Four SFP Combo Ports Three open slot ...

6 Front Panel Components DGS-3612 • Twelve 10/100/1000BASE-T ports • Four Combo SFP ports located to the right • One female DCE RS -232 DB-9 console port • LEDs for Power, Console, RPS, and Link/Act/Speed for each port Figure 1- 1. Front Panel of the DGS-3612 DGS-3612G • Twelve SFP 100/1000Mbps ports • Four Combo 1000BASE-T ports located to the right • One female DCE RS -232 D ...

7 DGS-3650 • Forty-eight 10/100/1000BASE-T ports • Four Combo SFP ports located to the right • One female DCE RS -232 DB-9 console port • LEDs for Power, Console, RPS, Link/Act/Speed and 10GE for each port • Stacking Module Numbered LED Figure 1- 5. Front Panel of the DGS-3650 LEDs The following table lists the LEDs located on models of the xStack® DGS-3600 Series switches along ...

8 Figure 1- 6. DGS-3612G LEDs Figure 1- 7. DGS-3627 LEDs Figure 1- 8. DGS-3627G LEDs Figure 1- 9. DGS-3650 LEDs Figure 1- 10. DGS-3612 LEDs ...

9 Rear Panel The rear panels of the DGS-3612, DGS-3612G, DGS-3627, DGS-3627G and the DGS-3650 are described below. DGS-3612 and DGS-3612G The rear panel of the DGS-3612 and the DGS-3612G contains an AC power connector, and an outlet for an optional external RPS. Figure 1- 11. Rear panel view of the DGS-3612 Figure 1- 12. Rear panel view of the DGS-3612G DGS-3627 and DGS-3627G The rear panel ...

10 Side Panel The right-hand side panel of the Switch contains a system fan and ventilation along the entire right side. The left hand panel includes a system fan and a heat vent. The system fans are used to dissipate heat. Do not block these openings on either side of the Switch. Leave at least 6 inches of space at the rear and sides of the Switch for proper ventilation. Be reminded that w ...

11 Section 2 Installation Package Contents Installation Guidelines Installing the Switch without the Rack Installing the Switch in a Rack Mounting the Switch in a Standard 19" Rack Power On Power Failure Installing the SFP Ports Optional 10GE Uplink Module External Redundant Power System Package Contents Open the shipping carton of the Switch and carefully unpack its contents. The carton sh ...