Ekars EPT-2201A Operating Manual

2. Features -------------------------------------------------------------------------------------------------- 3 3. Front Panel Controls -------------------------------------------------------------------------------- 4, 5 4. Rear Panel Cont ...

2 Although it is neither complicated to install nor difficult to operate your Digital Tuner a few minutes of your time is required to read manual for a properly wired installation and becoming familiar with its many features and how to use them. Please take a great care in unpacking your Digital Tuner and do not discard the carton ...

This tuner is able to the memory twenty-four broadcasting frequencies of each AM/FM. STEREO XLR OUTPUT 24 FREQUENCY MEMORIES 6+6+6 FM Presets. 6 AM Presets. Retains Presets When Power is off. Large LCD Digital Display. Scan and Seek Functions. Auto Store Memory Functions (A/PS). DC 24V Operation. Standard 1 Space EI ...

2. FREQUENCY DISPLAY 3. BAND BUTTON 4. TUNE UP/DOWN BUTTON TUNE UP : TUNE DN : Pushing this switch shortly, Unit is turned on and operated. Pushing this switch more than 2sec, Unit is turned off and is become the stand-by state. cf. Even if you press any switch, this unit is turned on and operated. You can confirm the frequency of tuner throu ...

5. MEMO 1~ MEMO 6 SELECTION BUTTON How to memory : 6. STAND-BY INDICATOR 7. GAIN CONTROL VOLUME This is PRESET switch to select pre-memorizes broadcasting channel on each switch. You can memory broadcasting channel which you want to listen, in each switch (1~6). Totally 24 channels (FM1 : 6Ch, FM2 : 6Ch, FM3 : 6Ch, MW1 : 6Ch) can be me ...

2. DC INPUT TERMINAL 3. STEREO OUTPUT JACK This terminal is for connecting the antennal. In the regions where FM broadcasting signal is poor, kindly install the outdoor antenna. This is the DC INPUT terminal for the DC 24V Input. This jack is the stereo output jack of this unit. This is for connection to the TUNER INPUT jack of Pre Ampl ...

INDOOR ANTENNA In the regions where FM broadcasting is heard comparatively well due to the near distance to the station or wooden structure, you can receive broadcasting of good quality by using a lead wire antenna. INSTALLATION OF ANTENNA USING THE COAXIAL CABLE Noisy reception may occur in built-up areas and factory sites as w ...

cable connector 75 coaxial Ω No. 7 8 9 75Ω coaxial cable and connector should be work in the following order. 2 Prepare the supplied antenna connector. 3 Disassemble the antenna connector. 4 Insert the coaxial cable into the right-side PVC cover. 5 Adhere the shield line of the coaxial cable to the body. 6 Make sure fixed with screws so as ...