Harbor Breeze BTH44ABZC5C Installation Manual

MODEL #BTH44ABZC5C BTH44BNK5C Questions, problems, missing parts? Before returning to your retailer, call or contact our customer service department at 1-800-527-1292, 8:30 a.m. - 5:00 p.m., CST, Monday - Friday. Harbor Breeze® is a registered trademark of LF, LLC. All Rights Reserved. Español p. 18 ATTACH ...

Safety Information .....................................………………………………………………...……..2 - 3 Package Contents .....……………………………………………………………..….….............4 Hardware Contents ........................................................... ...

marked "ACCEPTABLE FOR FAN SUPPORT OF 15.9 KG (35 LBS) OR LESS" and use mounting screws provided with the outlet box. Most outlet boxes commonly used for the support of lighting fixtures are not acceptable for fan support and may need to be ...

use the parts provided with this fan for proper installation and safety. PART DESCRIPTION QUANTITY PART DESCRIPTION QUANTITY N Motor Screw 10 (preassembled) O Lo ...

Fiber Blade Washer Qty. 15 BB CC AA Blade Screw Qty. 15 E3 Wire Connector Qty. 4 5 Before beginning assembly and installation of product, make sure all parts are present. Compare parts with package contents list and hardware contents above. If any part is missing or damaged, do not attempt to assemble the product. Contac ...

from any obstruction and at least 7 ft. above the floor. (Fig. 2) Turn off circuit breakers and wall switch to the fan supply line leads. (Fig. 1) DANGER: Failure to disconnect power supply prior to installation may result in serious injury or death. 1. 2. 3. 4. Secure mounti ...

shock, or personal injury, wire connectors provided with this fan are designed to accept only one 12 gauge house wire and two lead wires from the fan. If your house wire is larger than 12 gauge or there is more than one house wire to connect to the two fan lead wires, consult an electrician for t ...

that fits your situation and make appropriate wiring connections as follows: [NOTE: For each wire connection below, use one of the wire connectors (CC) provided, making sure to screw wire connector (CC) on in a clockwise direction.] 1A. FAN AND LIGHT CONTROLLED BY PULL CHAINS: Connect BLACK and ...

connector (CC) down to the wire as shown in Fig. 2. WARNING: Make sure no bare wire or wire strands are visible after making connections. Place green and white connections on opposite side of box from the black and blue (if applicable) connections. Turn spliced/taped wires upward and gently push ...

Fiber Blade Washer x15 BB Partially insert three blade screws (AA), along with three fiber blade washers (BB), into holes in blade (G) to attach blade arm (J) to blade (G). Then, tighten each blade screw (AA) starting with the one in the middle. (Fig. ...