3DR Solo Installation Instructions Manual

Phone: 1-888-919-2263 | Outside the U.S.: +1-845-343-4077 | Fax Line: +1-845-343-4299 Version 1.3 10MAR2017 ...

Safety Notes 2 SAFETY NOTES: Product Notes: • Do not disassemble or attempt to repair the product by yourself. • Do handle the product properly. This product may be damaged if dropped. • Do not use corrosive, alcoholic or organic-solvent-containing cleaners to wipe this product. • Do not use or store this product in ...

Modification Notice & Instructions MODIFICATION NOTICE & INSTRUCTIONS: NOTICE: In order to take advantage of the controlling features, the FLIR VUE PRO and FLIR VUE PRO-R Thermal Imaging Cameras will require a modification. This modification can be performed by OEM Cameras at no charge and the warranty on your thermal cam ...

FLIR VUE/VUE PRO Installation CONNECTING THE GIMBAL TO THE VUE/VUE PRO SERIES THERMAL CAMERAS: In this section we will show how to: • Connect the FLIR VUE Thermal Camera to the Gimbal • Connect the FLIR VUE PRO / PRO-R Thermal Camera to the Gimbal NOTE: THE VUE SERIES CAMERAS SHOULD BE INSTALLED TO THE GIMBAL BEFORE A ...

FLIR VUE/VUE PRO Installation CONNECTING THE GIMBAL TO THE VUE/VUE PRO SERIES THERMAL CAMERAS: Step 3: Plug the USB connector on the gimbal, into the VUE Series Camera and secure using the four short allen-head screws provided. (Fig. 6) Step 2: Align to the USB Connector to the cover plate. The holes are aligned differen ...

Installing the Gimbal GIMBAL INSTALLATION: In this section we will show how to: • Disconnect the Current Gimbal. • Connect the Thermal Gimbal Assembly to the 3DR SOLO. Before You Begin: Before installing, please remove the battery or any power source from the 3DR SOLO. Removing the cover plate: If there is no Gimbal a ...

Installing the Gimbal GIMBAL INSTALLATION: Uninstalling your current Gimbal Assembly: If you have a gimbal currently attached to the SOLO, it will need to be re- moved before installing the 3DR Solo Thermal Gimbal Assembly. Loosen the three self retaining screws with the provided Phillips screwdriver. Carefully lift up th ...

Installing the Gimbal GIMBAL INSTALLATION: Disconnect the Power / Data Cable by pressing the locking tab and gently lifting the connec- tor straight up from the board as shown: (Fig. 11&12) To disconnect the HDMI cable, gently sepa- rate the cable from the connection by pulling away from the board. (Fig. 13&14) Once you h ...

Installing the Gimbal GIMBAL INSTALLATION: The Philips screwdriver (included), will be the only tool needed for installation. Before connecting: The three position Camera Select Switch will allow the thermal gimbal to pass certain information to the remote controller and the 3DR Solo App. Be sure to select the correct pos ...

Attaching the Gimbal 10 ATTACHING THE GIMBAL ASSEMBLY TO THE 3DR SOLO: Attaching the Gimbal to the 3DR SOLO: Tuck the excess cable into the 3DR SOLO making certain that the wires are not pinched between the seams. (Fig. 17) With the screwdriver provided, tighten the three mounting screws to secure the gimbal to the 3DR SOLO ...