Ozito DP-350 Instruction Manual

INSTRUCTION MANUAL DP-350 WHAT’S IN THE BOX IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU MUST RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS WAREHOUSE WITH YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO RETURNING YOUR PRODUCT FOR WARRANTY PLEASE TELEPHONE OUR CUSTOMER SERVICE HELPLINE: Australia 1800 069 486 New Zealand 0508 069 486 3 yEAR REplAcEmENt WARRANty Your product is guaranteed for a period of 36 months from the original d ...

mobile device to take you to the online manual. 0 10 20 30 40 50 0 10 20 30 40 50 Assembling the drill press 1. Carefully remove contents from the packaging. 2. Select a firm, level surface on which to assemble the drill press. 3. Select the base and align the column over the large hole. Align the holes in the column support with those in the base and secure in place using the 3 column support bolts, spring a ...

1. Using the chuck key, loosen the jaws of the chuck by rotating in an anti-clockwise direction. 2. Insert the drill bit fully into the 13mm keyed chuck. 3. Whilst holding the drill bit in one hand, rotate the top collar of the 13mm keyed chuck in a clockwise direction. Ensure that you tighten all 3 holes in the 13mm keyed chuck using the chuck key to securely tighten the jaws and hold the drill bit in position. 6. ...

1. Loosen the table support lock. Adjusting the table angle The table can be adjusted up to 45° to the left or right. 1. Loosen the table support angle bolt (located below the table) by rotating anti- clockwise using an 18mm spanner or shifter (not supplied). 2. HEiGHt & ANGLE AdjuStMENtS 3. dEPtH AdjuStMENtS ADJUSTMENTS 0 10 20 30 40 50 0 10 20 30 40 50 0 10 20 30 40 50 0 10 20 30 40 50 0 10 20 30 40 50 0 10 20 30 40 50 WAR ...

Note: The pulley cover is fitted with a safety switch and must be closed to operate the drill press. 1. Switch the drill press on by pressing the green (I) button on the switch. 2. Switch the drill press off by pressing the red (O) button on the switch. 3. Secure your workpiece to the table if possible, use a vice or clamps (not supplied). operating the drill press 1. Ensure the drill press is switched off and disconnected from the ...

1. Ball bearings are packed with grease at the factory. No further lubrication of bearings is required. 2. Lubricate all moving parts periodically. Wipe the column, table and base with an oily cloth to minimise corrosion. 3. Keep air vents clean of dust and dirt. 4. Remove dust and dirt from the drill press regularly with a soft cloth, brush or compressed air. 5. If the power cord is damaged, have ...

WARNING! When using mains-powered tools, basic safety precautions, including the following, should always be followed to reduce risk of fire, electric shock, personal injury and material damage. Read and understand the manual prior to operating this tool. Save these instructions and other documents supplied with this tool for future reference. The electric motor has been designed for 230V and 240V only. Always check that the pow ...

not start Power cord not connected to the mains power supply Ensure that the power cord is connected to the mains power Power fault Check the mains power supply Power cord damage Use an authorised service centre to repair or replace Faulty switch or motor Use an authorised service centre to repair or replace Pulley cover not secured Check the pulley cover is closed and lowered correctly in position Noisy operation Inco ...