Rheem 96V Series Installation Instructions Manual

COMMUNICATING GAS FURNACES W/ECM BLOWER (-)96V SERIES & (-)(-)96MDV SERIES U.L. and/or C.S.A. recognized fuel gas and CO (carbon monoxide) detectors are rec- ommended in all applications, and their installation should be in accordance with the manufacturer’s recommendations and/or ...

1 TABLE OF CONTENTS. . . . . . . . . . . . . . . . . . . . . . . 2 2 GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . 3 Receiving . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 California Proposition 65 Note . . . . . . . . . . . . . . . . . . 4 Ch ...

6 PRESSURE SWITCHES, HIGH & LOW STAGE 7 EXHAUST TRANSITION 8 COUPLING (ELBOW TO TRANSITION) 9 EXHAUST 10 SHIPPING PLUG 11 FLAME SENSOR 12 OVER TEMPERAT ...

Install units in Canada in accordance with CSA-B149, local installation codes and authorities having jurisdiction. CSA-B149.1 is available from: CSA INTERNATIONAL 5060 Spectrum Way Mississauga, Ontario Canada L4W 5N6 online: www.csa.ca NOTICE: Any equipment immersed in water (including by flooding) must ...

GAS SUPPLY ______ Correct pipe size (record size) ______ Correct supply pressure (during furnace operation) ______ (record pressure) ______ Manifold pressure (record upstream pressure) ______ No gas leaks ______ L.P. Kit Number (if applicable) (record kit number) ELECTRICAL ______ 115 V.A.C. supply ...

THIS FURNACE IS NOT APPROVED FOR INSTALLATION IN A MOBILE HOME. DOING SO COULD CAUSE FIRE, PROPERTY DAMAGE, PERSONAL INJURY OR DEATH. ! WARNING INSTALL THIS FURNACE ONLY IN A LOCATION AND PO- SITION AS SPECIFIED IN THE LOCATION REQUIRE- MENTS AND CONSIDERATIONS SECTION OF THESE IN ...

INDOOR AIR QUALITY Central cooling and heating equipment is only as efficient as the duct system that carries the cooled or heated air. To maintain efficiency, comfort and good indoor air qual- ity, it is important to have the proper balance between the air supplied to each room and the air returning to the coolin ...

IMPORTANT! THE COMMONWEALTH OF MASSACHU- SETTS REQUIRES COMPLIANCE WITH REGULATION 248 CMR 4.00 AND 5.00 FOR INSTALLATION OF THROUGH-THE-WALL VENTED GAS APPLIANCES AS FOLLOWS: (a) For all side wall horizontally vented gas fueled equip- ment installed in every dwelling, building or structure used in whole or in part for re ...

ing or living area, be certain to install an auxiliary con- densate drain pan under the entire unit. This auxiliary drain pan should extend under any evaporator coil in- stalled with the furnace and the open portion of the condensate drain assembly. See “Condensate Drain/Neutralizer” section ...

posed, or existing, duct system. 2. Give consideration to the vent system piping when se- lecting the furnace location. Be sure the venting sys- tem can get from the furnace to the termination with minimal length and elbows. 3. Locate the furnace near the existing g ...