TE LDM-1000 Operation Manual
Text of the manual
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 1
OPERATION MANUAL
LDM-1000
LVDT/RVDT Signal Conditioning Module
LVDT/RVDT Signal Conditioning Module
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 2
Table of Contents
1.
Introduction ......................................................................................................................................................3
2.
Product Specifications .......
LVDT/RVDT Signal Conditioning Module
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 3
1. Introduction
The LDM-1000 is an extremely versatile LVDT/RVDT (Linear or Rotary Variable Differential Transformer) signal conditioning
module. The module supplies an AC sine wave excitation to the LVDT or RVDT, and d
LVDT/RVDT Signal Conditioning Module
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 4
3. Product Description
DIP switches are provided to allow selection of three transducer excitation frequencies (2.5, 5 and 10 kHz), two signal bandwidths
(250 or 1,000 Hertz), and two excitation voltages (1 or 3 Volts R
LVDT/RVDT Signal Conditioning Module
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 5
The list below is the minimum information required to perform a successful calibration:
Recommended LVDT or RVDT excitation frequency (to set the oscillator frequency)
LVDT or RVDT Output sensitivity at the exci
LVDT/RVDT Signal Conditioning Module
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 6
4. 2. Internal Switches
There are two internal DIP switch sets (SW1 and SW2) on the PC board assembly of the LDM-1000. The tables below explain
the switch positions and functions.
Switch Set SW1
Function:
Offset
Signal
LVDT/RVDT Signal Conditioning Module
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 7
4. 4. Oscillator ‘Sync’ Mode
The Oscillator ‘Sync’ mode setting will depend on the number of LDM-1000’s and transducers in your system, and their physical
locations. For a single LVDT or RVDT system you will b
LVDT/RVDT Signal Conditioning Module
TE CONNECTIVITY SENSORS /// LDM-1000 OPERATION MANUAL
P/N 09290100-000 REV. C
05/2016
Page 8
5. Dimensions and Wiring Terminals