Team Electronic PT-2208S Manual 

TEAM PT-2208S electronic Bedienungsanleitung Manual Mode d’emploi Freenet- & optional erweiterbares VHF- Betriebsfunkgerät ...

2) Kontrolllampe 3) Kanaldrehwahlschalter, 16stufig [1 – 15, S] 4) Lautstärkeregler, kombiniert mit Ein-/Aus-Schalter [VOLUME/OFF] 5) PTT-Taste [PTT] 6) Monitor-Taste 7) Doppelbuchse Ø 2,5/3,5 mm [SPK/MIC] 8) Lautsprecher 9) Akkumulator 1 2 3 4 5 6 7 8 9 Anzeige- und Bedienelemente: 1) detachable antenna / SMA connec ...

page Displays and Controls 2 Setting Up the TEAM PT-2208S 12 Mounting of the Accumulator 12 Mounting and Removing of the Belt Clip 12 Operation of the TEAM PT-2208S 13 1) Turning the Unit On/Off 13 2) Volume Level Adjustment 13 3) Channel Selection 13 4) Transmission 13 5) Reception 13 6) Sockets for External ...

Unpack carefully your UHF radio PT-2208S. Please check whether the supplied material matches with the positions listed below. In case of loss or damage of a part contact your carrier at once. This transceiver is a heavy duty Freenet radio, which can be optionally modified by your dealer also into a professional transceiver togeth ...

1) Turning the unit On/Off To turn on the unit rotate the volume control with ON/OFF switch [VOLUME/OFF] ( 4 ) from its rest position clockwise until you hear a click. A short beep tone will be heard from the loudspeaker ( 8 ), which indicates that the unit is in reception mode. To switch off the unit rotate the volume control ...

Behind the screw-fixed cover on top of the unit’s right side you can find two jack sockets for stereo plugs Ø 2,5/3,5 mm [SPK/MIC] ( 7 ). They serve for the connec- tion of a speaker-microphone with PTT function or for a separate microphone or a separate speaker. As already indicated on the cover, the upper socke ...

When you turn the rotary channel selector on position [S] ( = 16 ) the unit runs through all chan- nels which your dealer has selected for the scan function ( scanning list ). If there is a radio operator signal on one channel which is strong enough to open the squelch, the scan function will pause on that channel. You can hear ...

The lockout function for busy channels has the effect to prevent the unit from interfering with oth- er stations. If there is a signal on the actual channel at the moment when you press the PTT key, the transmitter will not be switched on. In this situation you will only hear a warning tone in the speaker. When you release th ...

ble value and to benefit the most of the set’s features, keep the following in mind: In transmission mode, keep the unit in a vertical position at a distance of 2 inches away from your face. Keep the antenna at a distance of at least 3 inch away f ...

Selected Channel Selected Channel or Prior Channel Prior Channel or actual Channel actual Channel Function of the Monitor Key Out of Function Stopping briefly Stopping Stopping briefly CTCSS & DCS CTCSS & DCS Noise Squelch in toggle mode CTCSS & DCS Transmit Time-Out-Timer Duration [s] 6) T ...