Thrustmaster MFD Cougar Operation & User’s Manual

Text of the manual

1. 28 backlit programmable buttons

2. 2 programmable identification LEDs 3. 2 adjustable attachment rods 4. Removable base 5. 4 bore covers 6. 2 attachment thumbscrews 7. USB connector 8. 2 removable rod attachment screws 9. Rod attachment system 10. Removable rod 11. 2 Plexiglas windo

GETTING TO KNOW YOUR MFD COUGAR

The THRUSTMASTER MFD COUGAR is the exact replica of the MFDs equipping U.S. Air Force F-16 fighters. Each MFD COUGAR features 20 buttons and 4 switches, i.e. 28 buttons per MFD in total! The MFD's features enable you to allocate advanced keyboard or mouse controls to the device and to emulate various flight instruments,

ADJUSTING THE MFD'S ANGLE ON THE BASE

When the MFD is attached to the base (4), its angle can be adjusted to 72, 54 or 39 degrees. The attachment device (3) is comprised of 2 rods that can be set at an angle or removed: - One long rod (featuring the indications 72DEGREE and 54DEGREE) - One short rod (featuring the indication 39DEGREE) ADJUSTING THE AN

ADJUSTING THE ANGLE TO 54 DEGREES

- Place the 2 attachment rods, with the 54DEGREE indication facing down (if required, slightly loosen the centre screw to facilitate angle adjustment). - Insert the upper end of the rods in the attachment system (9) located at the back of the MFD, on the device's upper side. - Attach the lower end of the rods to t

ADJUSTING THE ANGLE TO 39 DEGREES

- Loosen the centre screw, then remove all the rods. - Place the short attachment rods, with the 39DEGREE indication facing down. - Insert the upper end of the rods in the attachment system (9) located at the back of the MFD, on the device's upper side. - Attach the lower end of the rods to the back of the base,

ATTACHING THE MFD TO A COCKPIT OR A SCREEN

1) Detach the attachment rods and remove the MFD from the base by fully unscrewing the 2 attachment thumbscrews (6). 2) Detach the removable rod (10) located at the back of the MFD, on the device's upper side, by fully unscrewing the 2 attachment screws (8) located to either side. 3) Remove the 4 bore covers (5

PERSONALISING THE MFD COUGARS

- Insert the 2 included Plexiglas windows (11) in the relevant slot located at the top of the MFD COUGAR. - Between the 2 Plexiglas windows, insert the relevant graphic or one of the cards supplied with the pack. NOTES: - Flight Simulator X cards (available in English only) are included in this pack. - You can also downl

Other Video Game Controller Manuals