Toro 31200 Operator's Manual

Groundsmaster® 360 4-Wheel Drive Multi-Purpose Machine Model No. 31200—Serial No. 316000001 and Up Register at www.Toro.com. Original Instructions (EN) *3397-630* A ...

Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Genuine Toro spark arresters are approved by the USDA Forestry Service. It is a violation of California Public Resource Code Section 4442 or 4443 to use or operate the engine on any forest-covered, brush-covered, or grass-covered land unless the engine is equipped with ...

General Safety......................................................... 4 Safety and Instructional Decals ................................. 4 Setup ............................................................................ 9 1 Adjusting the ROPS .............................................. 9 2 Checking the Tire Pressure..................................... 9 3 ...

5395:2013 and ANSI B71.4-2012. Improper use or maintenance by the operator or owner can result in injury. To reduce the potential for injury, comply with these safety instructions and always pay attention to the safety alert symbol, which means Caution, Warning, or Danger—personal safety instruction. Failure to comply with the instruction may result in personal injury or death. General Safet ...

2. Cutting/dismemberment hazard, hand; entanglement hazard, belt—stay away from moving parts, keep all guards and shields in place. 117-3272 1. Warning—read the Operator's Manual; failure to us the rollover protection system (ROPS) can result in injury in the event of a rollover; wear a seat belt when a ROPS is in place, do not wear a seat belt when ROPS is lowered. 106-2353 1. Electrical power point ...

from the machine. 2. Thrown object hazard—do not operate the mower with the deflector up or removed, keep the deflector in place. 3. Cutting/dismemberment hazard of hand or foot, mower blade—stay away from moving parts. 106-9206 1. Wheel torque specifications 2. Read the Operator's Manual. 117–2718 115-0492 1. Height of cut (top number: mm, bottom number: inches) 117-3273 1. Warning� ...

Operator's Manual before servicing or performing maintenance. 2. Thrown object hazard—do not operate the mower with the deflector up or removed, keep the deflector in place; keep bystanders a safe distance from the machine. 3. Cutting/dismemberment hazard of hand or foot, mower blade—stay away from moving parts. 125-4399 1. Lower the deck 4. Slow 7. Engine—start 2. Raise the deck 5. Engine—stop 8. 2- ...

1. Explosion hazard 6. Keep bystanders a safe distance from the battery. 2. No fire, open flame, or smoking 7. Wear eye protection; explosive gases can cause blindness and other injuries. 3. Caustic liquid/chemical burn hazard 8. Battery acid can cause blindness or severe burns. 4. Wear eye protection 9. Flush eyes immediately with water and get medical help fast. 5. Read the Operator's Manua ...

Procedure Description Qty. Use 1 No parts required – Adjust the ROPS. 2 No parts required – Check the tire pressure. 3 No parts required – Check the levels of the hydraulic fluid, engine oil, and coolant. Media and Additional Parts Description Qty. Use Operator's Manual 1 Read the manual before operating the machine. Engine operator's manual 1 Read the manual before ope ...

No Parts Required Procedure The tires are overinflated for shipping. Therefore, release some of the air to reduce the pressure. Check the tire pressure; refer to Checking the Tire Pressure (page 36). 3 Checking the Fluid Levels No Parts Required Procedure 1. Check the level of the hydraulic fluid before starting the engine; refer to Checking the Hydraulic System (page 42). 2. Check the level of the engine oil before starting th ...

latch retracts. Tilt-Steering Pedal To tilt the steering wheel toward you, press the foot pedal down and pull the steering tower toward you to the most comfortable position and then release the pedal (Figure 4). Engine-Speed Switch The engine-speed switch (Figure 5) has 2 modes to change the engine speed. By momentarily tapping the switch, you can increase or decrease the engine speed in incremen ...

The InfoCenter LCD display shows information about your machine such as the operating status, various diagnostics and other information about the machine (Figure 7). There is a splash screen and main information screen of the InfoCenter. You can switch between the splash screen and main information screen, at any time, by pressing any of the InfoCenter buttons and then selecting the appropriate directional arrow. 1 g020650 ...

InfoCenter Bad or failed Bulb Output of TEC controller or control wire in harness Switch Operator must release switch Operator should change to indicated state Symbols are often combined to form sentences. Some examples are shown below Operator should put machine in Neutral Engine start denied Engine shutdown Engine coolant too hot DPF ash accumulation notification. Refer to Servicing the Diesel Particulate Filter (DPF ...

LCD display LCD Contrast Controls the contrast of the LCD display Protected Menus Allows the superintendant/mechanic to access protected menus by inputting a passcode Auto Idle Controls the amount of time allowed before returning the engine to low idle when the machine is stationary Only "operator-faced" text is translated. Faults, Service, and Diagnostics screens are "service-faced." The titles will be in the s ...

(cont'd.) 62 inch base mower deck 1,324 kg (2,918 lb) 100 inch rear discharge mower deck 1,510 kg (3,330 lb) Attachments/Accessories A selection of Toro approved attachments and accessories is available for use with the machine to enhance and expand its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved attachments and accessories. Operation Note: Deter ...

and highly explosive. A fire or explosion from fuel can burn you and others and can damage property. • Fill the fuel tank outdoors, in an open area, when the engine is cold. Wipe up any fuel that spills. • Never fill the fuel tank inside an enclosed trailer. • Never smoke when handling fuel, and stay away from an open flame or where fuel fumes may be ignited by a spark. • Store f ...

converting to biodiesel blends. • Contact your distributor if you wish for more information on biodiesel. Filling the Fuel Tank 1. Park the machine on a level surface. 2. Shut off the engine and set the parking brake. 3. Clean around the fuel tank cap and remove the cap (Figure 8). Figure 8 1. Fuel gauge 2. Fuel-tank cap Important: Do not open the fuel tank when parked on a hill. The fuel c ...

cotter pins (Figure 9). Important: Ensure that the seat is secured with the seat latch. 4. To raise the roll bar, remove the hairpin cotter pins and remove the 2 pins (Figure 9). 5. Raise the roll bar to the upright position and install the 2 pins and secure them with the hairpin cotter pins (Figure 9). Important: Always use the seat belt when the roll bar is in the raised and locked position. Do not u ...

4-Wheel Steering Press the steering selector switch (Figure 10) to the rearward position. When the front wheels are not aligned in the forward position, the green light flashes and the machine remains in 2-wheel-steering mode until the 4 tires point straight ahead. Turn the steering wheel slowly to straighten out the wheels until the green light stops flashing and remains off. When the switch light is continuously off, th ...

You can adjust the seat to provide a smooth and comfortable ride. Important: To adjust the seat for the driver’s weight, the driver must be seated and the ignition key must be in the ON position. Adjust the seat for your body weight by pulling or pressing the weight-adjustment lever (Figure 13). The seat is adjusted correctly when the arrow is in the middle clear area of the viewing window. Within this viewing area, you can a ...