Toro 04052TE Operator's Manual

Greensmaster® 1000 Model No. 04052—Serial No. 200000001 and Up Model No. 04052TE—Serial No. 200000001 and Up Register at www.Toro.com. Original Instructions (EN) ...

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Because in some areas there are local, state, or federal regulations requiring that a spark arrester be used on the engine of this machine, a spark arrester is available ...

Toro Mower Safety...............................................5 Sound Pressure........................................... ...

owner can result in injury. To reduce the potential for injury, comply with these safety instructions and always pay attention to the safety alert symbol, which means Caution, Warning, or Danger—personal safety instruction. Failure to comply with the instruction may result in personal injury or death. S ...

and functioning properly. • Do not change the engine governor settings or overspeed the engine. Operating the engine at excessive speed may increase the hazard of personal injury. • Before leaving the operator’s position: – stop on level ground; – disengage the cutting unit and traction drive; ...

operation. If a switch should fail, replace the switch before operating the machine. • Using the machine demands attention. To prevent loss of control: – Do not drive close to sand traps, ditches, creeks, or other hazards. – Reduce speed when making sharp turns. Avoid sudden stops and starts. – ...

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 104-051 93-6098 93-7273 1. Thrown object hazard—keep bystanders a safe distance from the machine. 2. Cutting hazard of hand or foot—stay away from moving parts. 93- ...

2. Fire hazard—no fire, open flames, or smoking; when adding fuel to the tank, leave space between the fuel and the top of the tank. 3. Thrown object hazard—keep bystanders a safe distance from the machine. 4. Cutting hazard of hand or foot—stay away from moving parts 93-9356 1. Entanglement hazard—s ...

Procedure Description Qty. Use Handle 1 1 Cable tie 2 Install the handle. 2 Transport wheels (obtain separately) 2 Install the transport wheels. 4 No parts required – Adjust the cutting unit. 5 Grass basket 1 Install the grass basket. Media and Additional Parts Description Qt ...

bolts, washers, and lockwashers previously removed (Figure 3). 5. Secure the cables to the handle with cable ties. Adjusting the Handle 1. Remove the hairpin cotters from the ring pins on each side of the mower (Figure 2). 2. While supporting the handle, remove the ring pins from ...