Toro 74946 Operator's Manual

Z Master® Professional 6000 Series Riding Mower with 60in and 72in TURBO FORCE® Side Discharge Mower Model No. 74946—Serial No. 316000001 and Up Model No. 74947—Serial No. 316000001 and Up Register at www.Toro.com. Original Instructions (EN) *3400-952* A ...

This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. This spark ignition system complies ...

Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. Contents Safety ........................................................................... 4 Safe Operating Practices.............................. ...

result in injury. To reduce the potential for injury, comply with these safety instructions, and pay attention to the safety alert symbol , which means Caution, Warning, or Danger—“personal safety instruction.” Failure to comply with the instructions may result in personal injury or death. ...

crossing roads and sidewalks. Stop the blades if you are not mowing. • Be aware of the mower-discharge direction and do not point it at anyone. • Do not operate the mower under the influence of alcohol or drugs. • Use care when loading or unloading the machine into or from a trailer or truck. • Use ...

The following list contains safety information specific to Toro products and other safety information that you must know. This product is capable of amputating hands and feet, and of throwing objects. Always follow all safety instructions to avoid serious injury or death. This product is designed for cutting and recycling grass, or, when eq ...

1. The maximum slope you can safely operate the machine on is 15 degrees. Use the slope chart to determine the degree of slope of hills before operating. Do not operate this machine on a slope greater than 15 degrees. Fold along the appropriate line to match the recommended slope. 2. ...

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 58-6520 1. Grease 93-7818 1. Warning—read the Operator's Manual for instructions on torquing the blade bolt/nut to 115-149 N∙m (85-110 ft-lb). 99-8936 1. Machine sp ...

down. 2. To avoid injury or death from a rollover accident, keep the roll bar in the fully raised and locked position and wear the seat belt. Lower the roll bar only when absolutely necessary; do not wear the the seat belt when the roll bar is down. 3. Read the Operator's Manual; driv ...

117-0346 1. Fuel leak hazard—read the Operator's Manual; do not attempt to remove th ...