Sealey SUPERMIG130 Instructions Manual
Text of Sealey SUPERMIG130 Instructions Manual
SUPERMIG130 Issue No:2(L) 26/08/14
Original Language Version
© Jack Sealey Limited
WARNING! It is the user’s responsibility to read, understand and comply with the following:
You must check all electrical equipment and appliances to ensure they are safe before using. You must inspect power supply leads, plugs and all electrical
connections for wear and damage. You must ensure the risk of electric shock is minim
IMPORTANT: These instructions contain the information you require to prepare your machine for welding, together with a
maintenance and a troubleshooting section. The instructions are not intended to teach you how to weld. If you have no
experience, we recommend that you seek training from an expert source. MIG welding is relatively easy, but does require a
s
On the front of the welder is the ratings plate, giving the
following data:
1 - The standard relating to the safety and construction
of arc welding and associated equipment.
2 - Inverter-transformer-rectifier.
3 - Welding with a continuous flow of welding wire.
4 - Single-phase AC supply.
5 - Rating of internal protection provided by casing.
6
Turning feed roller IMPORTANT: Turn the feed roller to suit the wire size.
There are two grooves on the feed roller, 0.6mm and 0.8mm. Always have the groove that is being
used on the outside of the roller (nearest to you). To turn the feed roller first loosen the wire tension
knob and move it into its down position (see fig.9-1) then move the tensioning